A technician applying a lining coat to the inner wall of an emptied water tank
What our clients rate us

Water tank sealing in Harat Al Kanadirah Jeddah

Harat Al Kanadirah in Thuwal depends on storage tanks to hold water brought by tanker trucks, and the older tanks here face salt spray from the Red Sea air and seepage from damp soil. Mixed housing of old and new buildings means tanks of all ages and conditions, with cracks and joints allowing salt and debris to enter.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Harat Al Kanadirah

Residents rely on storage tanks because water arrives by tanker truck, and tanks here suffer from sea salt exposure and high humidity from proximity to the shore. The method is set out in full on the full Water tank sealing page.

The first reason

Old tanks in traditional houses

Traditional homes in the quarter hold tanks built decades ago from simple cement. Deep cracks and weak joints between floor and wall allow moisture and salt to enter.

The second reason

Sea salt and coastal humidity

Proximity to the Red Sea means high humidity and salt-laden air that seeps into tanks. Stored water becomes contaminated through cracks and external seepage.

The third reason

Tanker water needs secure storage

Residents buy water from tankers and store it for long periods. Weak tanks do not preserve water quality and may cause illness.

The character of Harat Al Kanadirah

Mixed district: shops at street level with homes above them

The quarter mixes old traditional houses with modern homes, meaning tanks of widely different ages and conditions. Old tanks need full internal and external sealing, while newer tanks may only need repair of weak points.

Before treatment

What we read before any material is opened

A mixed residential quarter in Thuwal on the Red Sea coast at the far north of Jeddah governorate, with older traditional houses alongside modern concrete homes. The Thuwal wadi defines the south, the university campus closes it to the north, and the Jeddah to Madinah road runs along the east.

A fine crack running through a concrete wall

Cracking in the wall

Deep cracks in the floor allow seepage of salty water from damp soil beneath the tank.

The junction of a concrete floor and wall inside an empty tank

The floor to wall joint

Floor-to-wall joints are weak in old tanks here, and salt and external moisture enter through them.

A coating flaking away from a concrete surface

The condition of the old lining

Pipe entry points were not sealed properly in old tanks, allowing leakage around the pipes.

Limescale deposits inside a water pipe

Sediment and scale

High humidity from coastal proximity causes gradual breakdown of the outer cement layer.

Water pipes passing through a concrete wall

The pipe entries

Tank floor collects sand and debris that entered through cracks, reducing storage capacity.

A metal cover over a water tank opening

The hatch and the vent

Tank sterilisation after sealing is essential because stored water may have been contaminated by previous cracks and seepage.

How we work

  1. 1

    Inspect with the tank empty

    We drain it and read the surface dry: whether the water leaves through a crack, a joint or a pipe collar, and what the outer face of the wall and the ceiling below are telling us. A level test with the valves closed separates a leaking tank from leaking pipework.

  2. 2

    Clean and prepare the substrate

    Sediment out, a high pressure wash, the loose old lining and the weak surface layer of the concrete taken back, then dried. The material grips sound substrate and nothing else.

  3. 3

    Make the cracks and joints good

    Cracks are chased out and filled with a repair mortar, a cove is formed where the floor meets the wall, and every pipe collar is treated on its own.

  4. 4

    Lining, fill test, sterilisation

    Successive coats, each run across the one beneath it, on the face the water touches. Then a full cure, a fill with the level watched, and sterilisation with the first fill run to waste before the tank returns to use.

What water tank sealing includes

  • A technician inspecting with a flashlight

    Finding where the water leaves

    Carried out drained and dry: cracks, joints, pipe collars and the outer face of the wall.

  • A metal floor drain

    Draining and sediment removal

    The last of the water and the settled layer on the floor come out, because a lining does not stick over sediment.

  • A gloved hand applying bait into a joint

    Cracks and joints made good

    The crack opened and filled, a cove formed at the floor to wall junction, and each pipe entry worked separately.

  • A spray nozzle in close detail

    Lining coats on the water face

    More than one coat, each crossing the one below, in material made for drinking water tanks rather than roof waterproofing.

  • A clean kitchen counter after treatment

    Curing, fill test and sterilisation

    The material is left to cure, the tank is filled and the level watched, then sterilised and the first fill run to waste. How long the cure takes follows the material and the weather, and we tell you before the date so you can plan around the supply.

  • The visit report being written on a clipboard

    A follow-up level check

    We come back once it is in service to read the level and check the outer face, because any remaining loss shows up then rather than on the day of the work.

What is different about Thuwal Sub-Municipality

Thuwal sub municipality is a small fishing town on the Red Sea coast at the far northern edge of Jeddah governorate. Its old quarters are closely packed popular and mud built houses on narrow streets, with newer low rise concrete homes from the town's development programme beside them. Sea humidity stays high all year, the fishing harbour and the corniche form its seafront, water arrives by tanker so household tanks are everywhere, and the town sits on Wadi Thuwal, ringed by open ground and by the irrigated green campus of King Abdullah University of Science and Technology.

Questions about this district

Why do tanks age faster here than in other places?

Sea salt and coastal humidity oxidise steel and weaken cement. Proximity to the shore means continuous salt exposure.

Does a slow leak from the tank mean I need full sealing?

Yes. A slow leak may accelerate quickly. Full sealing prevents contamination and loss.

How do we ensure stored water is safe after sealing?

We wash the tank after sealing and sterilise it before it is refilled with fresh water.

Do fine cracks in the floor and walls need treatment?

Yes. Even fine cracks allow salt and debris to enter. Full sealing covers them.

Does sealing protect against external salt?

Good sealing creates a barrier between the tank and the salty soil below, but needs periodic maintenance.

How often does a tank need resealing?

It depends on sealing quality and salt exposure. Usually every 5 to 10 years depending on condition.

How much does water tank sealing in Harat Al Kanadirah cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Harat Al Kanadirah.

Other services in Harat Al Kanadirah

Other services we provide to residents of Harat Al Kanadirah.

All services

Need water tank sealing in Harat Al Kanadirah? Tell us what you saw and we will tell you what it needs

We reach Harat Al Kanadirah at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp