A technician washing the inside wall of a water tank with a pressure hose
What our clients rate us

Water tank cleaning in Al Farouq Jeddah

Al Farouq is a mixed district south of Jeddah between the ring road and Old Makkah Road, with apartment blocks, vacant plots, shops and light industry. Tanks here sit beneath buildings housing families and traders on the same premises, creating uneven demand that pressurises the tank unevenly throughout the day.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Al Farouq

Tanks here serve mixed-use buildings of mixed ages, and pipework runs beneath the streets and across vacant plots that may be contaminated from past uses. The method is set out in full on Water tank cleaning in detail.

The first reason

Mixed buildings create uneven pressure on a shared tank

Ground floor shops consume water all day at one rate while residential flats above use water at completely different times and volumes. This pressure fluctuation draws air into the tank more easily than in residential buildings.

The second reason

Nearby workshops and storerooms pollute the tank easily

Workshops and storage facilities nearby shed metal dust and oils. This dust settles on rooftops and ventilation openings and enters the tank both with air intake and through water circulation.

The third reason

Vacant plots collect moisture and contaminants all around

Undeveloped plots hold pooled rainwater and accumulated earth. Pipes running across them may leak or become contaminated from damp soil conditions.

The character of Al Farouq

Mixed district: shops at street level with homes above them

Mixed-use buildings mean tanks serve shops and homes together, and the uneven pressure patterns make cleaning and disinfection more technically complex.

Before treatment

The condition of the tank decides the method

The district sits between two main roads, surrounded by light industry and workshops on the southern side, with dust and emissions from traffic and factories entering through ventilation constantly.

Fine brown sediment beneath shallow water

The layer on the floor

The floor holds metal particles and commercial dust, with sediment accumulating faster than in purely residential districts.

Water turned green by algae

Light and algae

Algae grows from intermittent light and moisture rising from nearby vacant plots and industrial land.

A damp concrete wall carrying a dark deposit

The deposit on the wall

A brown layer of mineral deposits and faint oil residue coats the walls, requiring deep chemical cleaning.

A concrete surface with a fine hairline crack

The lining and hairline cracks

The lining cracks from constant pressure fluctuations caused by mixed residential and commercial water demand.

The lid of a water tank on a building roof

The lid and the access hatch

The lid and access hatch face constant industrial dust and soil disturbance, needing frequent cleaning.

A plastic pipe leaving the exterior wall of a building

The vent and the overflow pipe

Ventilation and overflow pipes are exposed to workshop dust and soil particles, needing monthly clearing.

How we work

  1. 1

    Inspect before the drain

    Tank type and material, the condition of the lining, the depth of the sediment, the lid and the vent, and where the drained water will go. We agree the window without supply before anything is opened.

  2. 2

    Drain, then lift the sludge

    The water leaves through the outlet, then the layer beneath it is taken out by hand and by suction. That layer is the reason for the visit, not the water that ran out ahead of it.

  3. 3

    High pressure wash

    Walls, floor and the joint where they meet, with a brush wherever the film resists, then the wash water is taken out completely so nothing we lifted settles again.

  4. 4

    Disinfect and put back in service

    Disinfectant over every internal surface, left for its contact time and then rinsed out, followed by the refill, a first draw off at the taps, and a report on what was inside the tank.

What water tank cleaning includes

  • A technician inspecting with a flashlight

    An inspection before the valve

    Tank type, lining condition, depth of sediment, lid and vent, recorded before any water leaves.

  • A metal floor drain

    Full drain and sediment removal

    The water through the outlet, and the layer below it by hand and by suction until the floor itself is showing.

  • A spray nozzle in close detail

    Pressure washing walls and floor

    High pressure across the surfaces and corners, and a brush on anything water alone will not lift.

  • A gloved hand applying bait into a joint

    Disinfection after the wash

    A disinfectant intended for drinking water tanks, named to you before it is used, left for its contact time and then rinsed out.

  • A clean kitchen counter after treatment

    Refill and the first draw off

    We refill, run the taps so the new water moves through the pipework, and tell you when it is ready to use.

  • The visit report being written on a clipboard

    A report and the next date

    What was inside the tank, anything on the lid or the lining that needs repair, and a sensible date for the next clean.

Landmarks of Al Farouq

Tanks in Al Farouq sit beneath apartment blocks along Haramain Road and Al Falah Road. Access routes must coordinate with both commercial and residential tenants on shared rooftops.

  • Old Makkah Road
  • Haramain Road
  • Al Falah Road
  • Abdullah ibn Rawahah Mosque
  • Imam Ahmad ibn Hanbal Mosque
  • Al Farouq Park

Questions about this district

The residential water looks different from the shop water below. Why?

If they share one tank, the difference may stem from different consumption rates or the condition of the supply pipes serving each part separately.

There is a faint smell of oil and metal in the water. Are nearby workshops the cause?

Workshops generate metal and oil dust. If ventilation openings are compromised, water can carry metal traces or faint odours. Good filtration helps reduce this problem.

First water after repair work is reddish from iron. When will it clear?

New or reused pipes shed rust even after initial flushing. Running water continuously for two or three hours usually clears the red discolouration.

Vacant plots nearby hold standing water. Does this affect the tank?

Damp plots and stagnant water can contaminate pipes running beneath them. Regular inspection of underground pipework helps prevent problems.

The old tank is showing cracks around it now. Is that dangerous?

Cracks allow ground water and contaminants to migrate in. Engineering inspection is essential, and the tank may need repair or replacement.

Is mixed-building water safe to use if it is cleaned regularly?

Yes, provided cleaning and disinfection follow a proper schedule. Mixed-use tanks need more frequent cleaning than purely residential tanks.

How much does water tank cleaning in Al Farouq cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Farouq.

Other services in Al Farouq

Other services we provide to residents of Al Farouq.

All services

Need water tank cleaning in Al Farouq? Tell us what you saw and we will tell you what it needs

We reach Al Farouq at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp