Water tank cleaning in Shaab Amer Al Jadid, Makkah

Potable-rated materials

Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
You get the downtime first

How many hours the tank is out of service, told before we start rather than after we finish.
A first-draw flush

We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
Ground and roof tanks

Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Shaab Amer Al Jadid

New scheme tanks need cleaning more frequently than established quarters because construction dust and ongoing building activity around the homes creates constant contamination. The method is set out in full on our Water tank cleaning service.

The first reason

Construction dust and active building work

The scheme is newly developed and building continues. Dust from neighbouring sites and machinery enters tanks far more readily than in completed neighbourhoods. Small gaps and hairline cracks in new structures allow suspended particles to settle during construction phases, and access routes disturb previously settled layers.

The second reason

Wadi Uranah and seasonal water movement

The wadi bed crosses the surrounding land and groundwater levels rise seasonally. Seasonal flows and seepage from empty plots affect water clarity and accelerate sediment buildup in the tank floor. The water table fluctuations change how quickly deposits form and what kind of particles accumulate.

The third reason

Open land and unshaded exposure

Large gaps between homes and the empty plots surrounding them leave tanks fully exposed to wind, direct sun and open sky. This exposure speeds algae growth in summer, increases water loss to evaporation, and allows dust and organic particles to settle continuously into the tank.

Shaab Amer Al Jadid on the map

Shaab Amer Al Jadid sits about 3 km from Al Qararah Al Jadid and about 5.5 km from Al Mudaa Al Jadid.

Open in Google Maps

Before treatment

The condition of the tank decides the method

Wadi Uranah flows through the scheme between the Fifth Ring Road and Ibrahim Al Khalil Road, whilst the open plots leave tanks exposed to continuous wind and dust from the landscape.

Fine brown sediment beneath shallow water

The layer on the floor

Fine dust from neighbouring sites settles rapidly and forms a light grey-brown layer mixed with sand and airborne particles that differ from organic sediment in older areas.

Light and algae

Light penetrates the tank through gaps in new structures, so algae grow faster in summer and exposed tanks allow more sunlight to reach the water than sealed older installations.

A damp concrete wall carrying a dark deposit

The deposit on the wall

Walls retain a thin brown film of suspended minerals and delicate algae that do not adhere strongly like deposits in decades-old tanks, making removal straightforward.

A concrete surface with a fine hairline crack

The lining and hairline cracks

Hairline cracks are common in newly cast tanks where the lining has not fully hardened and structural stress remains unrelieved, though they rarely cause active leaks.

The lid of a water tank on a building roof

The lid and the access hatch

The lid and access hatches in new schemes need tight seals because ongoing construction causes vibration that loosens joints and disturbs previously settled material.

A plastic pipe leaving the exterior wall of a building

The vent and the overflow pipe

Vent and overflow openings need dust guards because open land brings fine particles continuously, and insects from building sites seek water sources where vents are unscreened.

How we work

1
Inspect before the drain

Tank type and material, the condition of the lining, the depth of the sediment, the lid and the vent, and where the drained water will go. We agree the window without supply before anything is opened.
2
Drain, then lift the sludge

The water leaves through the outlet, then the layer beneath it is taken out by hand and by suction. That layer is the reason for the visit, not the water that ran out ahead of it.
3
High pressure wash

Walls, floor and the joint where they meet, with a brush wherever the film resists, then the wash water is taken out completely so nothing we lifted settles again.
4
Disinfect and put back in service

Disinfectant over every internal surface, left for its contact time and then rinsed out, followed by the refill, a first draw off at the taps, and a report on what was inside the tank.

What water tank cleaning includes

An inspection before the valve

Tank type, lining condition, depth of sediment, lid and vent, recorded before any water leaves.
Full drain and sediment removal

The water through the outlet, and the layer below it by hand and by suction until the floor itself is showing.
Pressure washing walls and floor

High pressure across the surfaces and corners, and a brush on anything water alone will not lift.
Disinfection after the wash

A disinfectant intended for drinking water tanks, named to you before it is used, left for its contact time and then rinsed out.
Refill and the first draw off

We refill, run the taps so the new water moves through the pipework, and tell you when it is ready to use.
A report and the next date

What was inside the tank, anything on the lid or the lining that needs repair, and a sensible date for the next clean.

Landmarks of Shaab Amer Al Jadid

Shaab Amer Al Jadid lies between the Fifth Ring Road and Ibrahim Al Khalil Road, with tanks distributed across the residential plots among newly built homes where construction activity continues and Wadi Uranah crosses the surrounding open land.

Fifth Ring Road
Ibrahim Al Khalil Road
Wadi Uranah

Questions about this district

Why does the water turn cloudy so quickly in a new scheme tank?

Construction dust and active neighbouring sites enter the tank constantly, particularly through vent openings and pipe joints. Wind across the open landscape carries fine particles that settle on the floor and give the water a persistent grey haze.

Does the heavy sediment at the tank floor come from the water table?

Some does, but most is construction dust and soil minerals from the exposed earth around the development. Wadi Uranah raises the water table during rains, which increases the volume and type of sediment that accumulates on the floor.

Does a brand new tank need stronger cleaning than older tanks?

No, but it needs cleaning more often because dust enters faster. The material that settles in a new tank is lighter and lifts more easily than hardened deposits in old tanks, so the work is quicker but more frequent.

How often must a tank be cleaned while the scheme is still under construction?

At shorter intervals than completed areas, typically every two to three months rather than six. Ongoing building means dust enters steadily and waiting for heavy deposits to form leaves the water poor quality for too long.

Do insects and rodents from active sites enter a new tank easily?

Yes. Open plots and empty land attract insects, rodents and reptiles. Maintenance hatch seals and vent covers must be kept tight between cleanings, and gaps around pipe entries need checking regularly.

Does tank cleaning improve water quality if building keeps happening nearby?

Yes, immediately after cleaning, but water will gradually cloud again as construction continues. Regular cleaning maintains water quality through the building phase and remains essential once the scheme is complete.

How much does water tank cleaning in Shaab Amer Al Jadid cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Shaab Amer Al Jadid.