Tank leak repair in Shaab Amer Al Jadid Makkah
Shaab Amer Al Jadid lies at the far south of Jeddah under the Crown Prince scheme nine A, with new villas and apartment blocks under construction and wide empty plots separating them. Wadi Uranah passes through the district across bare open ground. Tanks here are modern but face stress from seasonal temperature swings and dry winds in this remote area.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Shaab Amer Al Jadid
Buildings are at various construction stages and ground around tanks remains bare. Large empty spaces mean tanks are fully exposed to direct sun, extreme heat and dry winds. The method is set out in full on how we approach Tank leak repair.
Extreme heat and expansion-contraction cycles
Plastic tanks face intense heat because land around the buildings is empty and unshaded. Heat causes the tank to expand and fittings to move and slip. Cold nights cause rapid contraction and cracks appear from repeated expansion-contraction cycles.
Dry winds and abrasion
The area is remote and dry winds are strong here. Humidity is very low but wind carries sharp dust striking tanks. Dust abrasion weakens plastic walls.
Wadi Uranah and seasonal floods
Wadi Uranah runs close to the district and may flood in rainy seasons. Floods may surround tanks and stress foundations. Water pressure from the wadi may cause leaks in buried pipes.
The character of Shaab Amer Al Jadid
New development: ongoing construction and vacant plots between the homes
New villas and apartments in Shaab Amer are isolated and unshaded because the district is remote and land is empty. Tanks face extreme heat, dry winds and sharp dust. Repair requires added heat and dust protection, not just crack sealing.
Where the water leaves decides how it is repaired
A new residential district at the far south of Jeddah under Crown Prince scheme nine A, with new villas and apartments on licensed plots, lying south of Al Qararah Al Jadid between the Fifth Ring Road and the southern extension of Ibrahim Al Khalil Road.
Damp and salt on the outside wall
Fine and deep cracks in the tank body show repeated expansion-contraction from seasonal heat swings.
The kind of crack
Water in soil around the tank may be from a small leak or from nearby wadi flooding.
The wall to floor junction
Buried pipes with visible abrasion marks and dust scoring from sharp dust and wind.
Pipe entries
Water level falling with float valve and outlet closed means internal leaks in the tank body.
The condition of the old lining
Fast water loss after flooding may be from cracks caused by water pressure.
What the tank is made of
Burnt plastic smell or colour change in the tank shows damage from extreme heat.
How we work
-
1
Inspect and locate the leak
We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.
-
2
Drain, clean and dry
We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.
-
3
Repair the cracks and the entries
We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.
-
4
Refill, test, then sterilise
We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.
What tank leak repair includes
-
A marked level test
A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.
-
Draining and sediment removal
Water and silt out of the base, so the floor and the walls can be seen as they really are.
-
Pressure wash and dry back
The weak layer and the dust come off, because a repair only holds on sound concrete.
-
Cracks opened and filled
The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.
-
Refill and a recorded test
We refill, read the level again and write the reading down, so the result is not a matter of opinion.
-
Sterilised and back in service
A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.
What is different about South Makkah Sub-Municipality
South Makkah sub municipality is the belt of Crown Prince schemes south of Al Ukayshiyah, along the Al Laith road and the extension of Ibrahim Al Khalil Road to the Fifth Ring Road and the Non Muslims bypass. Most of it is still bare: granted plots awaiting houses, new villas standing alone, open building sites and unfinished paving and drainage. Wadi Uranah and its tributaries cross the low ground and hold water after rain, hills close it in, and rodents, reptiles and scorpions shelter in stacked materials and foundation pits before the neighbourhoods fill up.
Questions about this district
Can heat alone cause tank leaks?
Repeated expansion and contraction weakens fittings and cracks form over time. Extreme heat in Shaab Amer causes faster leaks than other areas.
Why do tanks here crack faster than in older districts?
Tanks are new but exposure to heat, wind and dust is relentless. No nearby buildings provide shade or shelter.
Does wadi flooding cause tank leaks?
Flooding may bend buried pipes and cause leaks. If water surrounds the tank body, pressure can cause cracks.
How do we protect a tank from heat in such a remote area?
A fence or sand barriers can provide partial shade around the tank. Thermal insulation on the tank reduces expansion-contraction stress.
Can dust enter the tank through small cracks?
Yes, small cracks allow fine dust and moisture in. Cracks must be repaired and sealed before any lining is applied.
How does maintenance differ here from dense districts?
In Shaab Amer, maintenance focuses on shielding the tank from heat, wind and dust. In dense areas, it focuses on groundwater and pressure.
How much does tank leak repair in Shaab Amer Al Jadid cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Shaab Amer Al Jadid.
Nearby districts we cover
Other services in Shaab Amer Al Jadid
Other services we provide to residents of Shaab Amer Al Jadid.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sterilization
-
Water tanks
Water tank sealing
-
Residential
Cockroach control
Need tank leak repair in Shaab Amer Al Jadid? Tell us what you saw and we will tell you what it needs
We reach Shaab Amer Al Jadid at a time we agree, and you get the full cost before we start.