Water tank sterilization in Khalij Salman Jeddah
Khalij Salman is a coastal stretch on the Dhahban side of north Jeddah on the Red Sea, where chalets and small hotels stand among land subdivisions still developing around a shallow winding bay edged with coral reefs. Tanks here face very high salt moisture and seawater carries salt and marine sediment. Stagnant water, salt and harsh winds accelerate tank metal corrosion and buildup of salt-loving algae and bacteria.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Khalij Salman
Seasonal residents and workers in chalets report high salinity and metallic taste in water, and tanks require frequent sterilization. The method is set out in full on how we approach Water tank sterilization.
Chalets and small hotels exposed directly to the sea
Chalets and rest houses stand close to the sea and coral reefs. Salt moisture penetrates tank walls and metal structures corrode rapidly from salt and wind.
Vacant land subdivisions under development raise dust and sand
The area remains under development and vacant plots raise dust and salt from coastal sands. Dust and salt enter tanks through vent openings.
Seawater and salt sometimes enter water supply lines
During low pressure or pipe leaks, seawater may enter supply lines. Salt and marine sediment deposit rapidly in tanks.
The character of Khalij Salman
Coastal area: high humidity and salt air through the year
Khalij Salman is a severely salt-affected coastal area and chalets and hotels need tanks protected from salt and corrosion. Treatment focuses on frequent sterilization and protection from salt and marine sediment. Plastic tanks are superior to metal ones and sterilization must occur at least every three months.
What we read inside the tank before anything starts
A coastal stretch on the Red Sea on the Dhahban side of north Jeddah where chalets and small hotels stand among land subdivisions still being developed around a shallow winding bay edged with coral reefs. The area includes the Lakes City complex, a public beach and public park, reached from Al Haramain Road at Al Rahili or from Obhur.
Sediment on the floor
Salt and marine sediment deposit on tank floors forming thick layers of mineral and organic marine sediment.
The slime film on the wall
Marine algae and salt-loving bacteria multiply in saline water and high moisture, forming biofilm on tank walls.
Light and heat
Supply lines may hold salt and mineral deposits from seawater, and need repeated strong flushing.
The lining and any cracking
Salt moisture and sea air cause rapid corrosion of tank metals and pipes; sterilization must include corrosion protection.
The lid and the openings
Tank bases collect salt, marine debris and silt from wind and moisture; mechanical lift is essential to remove it.
What shows up at the tap
Flushing distribution lines from the furthest tap removes salt and marine sediment, and clean water must flow through all lines.
How we work
-
1
Inspect and record the condition
We open the hatch and work through what the tank is made of and how big it is, how deep the sediment lies, the state of the lining, whether the lid and the overflow seal, and whether there is a crack that has to be repaired before any sterilizing.
-
2
Drain and lift the sediment out
The water goes out, then the silt and sand are lifted off the floor by suction rather than pushed toward the outlet, because pushing them sends them into the house pipework and the heater.
-
3
High pressure wash
Walls, floor, corners and the area around the outlet, until the slime film is completely gone. This is the step that makes the sterilizing after it mean anything.
-
4
Sterilize, rinse, then return to service
The sterilizing agent goes onto the walls, the floor and the underside of the lid and is left for its contact time, then we rinse, refill and run the furthest tap until the whole line is clear.
What water tank sterilization includes
-
A recorded inspection
Material, capacity, sediment depth, the state of the lining, the lid and the overflow, all before any work begins.
-
Draining and sediment removal
The water out, and the silt and sand lifted off the floor instead of being pushed into the outlet and the house pipework.
-
High pressure washing
Walls, corners and around the outlet, until the biofilm that no disinfectant penetrates has gone.
-
Sterilizing the internal surfaces
A sterilizing agent meant for drinking water tanks, applied to the walls, the floor and the underside of the lid, and left for its contact time.
-
Line flush and aftercare
Rinse, refill and a flush from the furthest tap, when the water is usable again, and what to change in the filter afterwards.
-
The next cycle
We agree the right interval for your tank from how it is filled, how much sun it takes and the condition of the lid.
What is different about Dhahban Sub-Municipality
Dhahban sub municipality is the northern coastal strip of Jeddah, running from the north bank of Sharm Obhur up to the old village of Dhahban and Salman Bay. Its districts are recently built, with owner occupied villas and apartments, beach resorts and chalets on the shore, and land subdivisions still being developed. Nearness to the sea keeps humidity high all year, irrigated lawns in villas, resorts and district parks hold water, Wadi Obhur and the vacant plots between buildings give rodents and reptiles shelter, and the old fishing village of Dhahban gives the far north a rural edge.
Questions about this district
Why does water taste salty in Khalij Salman even if it comes from municipal supply?
High salt moisture and salt air cause salt to seep into water lines and tanks. Groundwater near the sea may also be naturally saline.
Are metal tanks better than plastic tanks on the coast?
No, metals corrode faster than plastic in salt air. Plastic tanks are better but still need frequent sterilization.
Is standard sterilization enough in Khalij Salman or do we need special treatment?
Standard sterilization may not suffice. Saline water and marine algae need special treatment to eliminate completely.
How often should a tank be sterilized per year in a coastal area?
In a salty coastal zone like Khalij Salman, at least every three months. Seasonal chalets may need sterilization before each tourism season.
Do high winds affect water quality in the tank?
Yes, winds lift salt and dust from sea and sand. These particles enter the tank through vent openings.
Can seawater enter supply lines on the coast?
Yes, during low pressure or pipe leaks, seawater may breach lines. Salt and marine sediment deposit rapidly.
How much does water tank sterilization in Khalij Salman cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Khalij Salman.
Nearby districts we cover
Other services in Khalij Salman
Other services we provide to residents of Khalij Salman.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sealing
-
Water tanks
Tank leak repair
-
Residential
Cockroach control
Need water tank sterilization in Khalij Salman? Tell us what you saw and we will tell you what it needs
We reach Khalij Salman at a time we agree, and you get the full cost before we start.