A pest control technician checking the base of a boundary wall with a torch

Scorpion control in Rai Adhakhir Makkah

Rai Adhakhir is an apartment district climbing the north eastern slopes above the Grand Mosque, where blocks stand terraced against the hillside with shared entrances and repeated floors that create natural corridors for scorpions. Scorpion control here focuses on the joints between floors, shared party walls and the common exits that all residents must pass through. The work differs sharply from villa districts where perimeter walls isolate each home.

Call now Message us on WhatsApp

Targeted, not broadcast

Product goes into cracks and runways, never sprayed across open surfaces.
Told before we start

What we will use, where it goes, and what to cover or move before we arrive.
A follow-up visit

We return after the first treatment, because what survives it does not show on the day.
Homes and businesses

Apartments and villas, and kitchens and stores that need a record of each visit.

Why they keep coming back in Rai Adhakhir

The tower blocks and close spacing between floors create ready-made pathways for scorpions, especially the middle storeys where darkness meets dampness from above and below. The method is set out in full on the full Scorpion control page.

The first reason

Shared floor joints in stacked buildings

The joints between flats and the terraced floors are the scorpion's first highway. In dense residential towers, these seams need careful treatment that does not harm the building fabric, and tight sealing that stops movement between storeys. Water that seeps between floors in the wet season makes these routes wet enough for insects to shelter.

The second reason

Common hallways and shared stairs

Unified entrances and interior stairwells are the vertical migrating routes that carry scorpions between floors. The dim light in stairways and landings attracts the small insects the scorpion hunts, so the scorpion follows them up.

The third reason

Outer walls and their junctions with older structures

The outer walls of high-rise blocks on the slopes gather moisture from surface runoff and the cold night air, and their seams with older annexed structures or service shafts harbour scorpions securely before they climb to the flats themselves.

Rai Adhakhir on the map

Rai Adhakhir sits about 1 km from Al Khansa and about 1.5 km from Al Jumayzah.

Open in Google Maps

Before treatment

What we check outside before we go in

The district is built on rising ground with streets that climb from Al Shisha and Al Maabdah towards Al Khansa. Buildings are pressed tightly together with party walls that hold moisture in the joints through the rains.

An exterior block boundary wall showing joints and cracks

Wall joints and boundary walls

The seams in party walls between flats hold continuous dampness and give scorpions safe shelter before they breach the internal boundary.

Blocks and stones stacked in the corner of a yard

Rubble and stacked block

Debris from maintenance and finishing work piles up in the corners of blocks and at the junctions between buildings, drawing in small insects.

Palm fronds and garden litter

Fallen leaves and twigs from nearby trees collect on the building roofs and in the gaps between structures, giving scorpions cover to move unseen.

The space between an exterior door and its threshold

The gap under the door

Gaps under flat doors and stairwell doors form direct passages, especially where old or loose fitting doors have begun to warp.

Irrigation and damp soil

External pipes and cables that run up the building facades create straight highways for scorpions, and the moisture around these areas draws the small insects they hunt.

A light fitting mounted on an exterior wall

The light by the door

Lighting in the building corridors and stairways attracts nocturnal insects, so scorpions move towards the lit zones especially on warm nights.

How we work

1
Night survey and perimeter inspection

We walk the perimeter after dark with an ultraviolet lamp, which makes a scorpion show up against wall and soil, and we record the harbourage, the ways in and how much prey is present.
2
Treat the harbourage and the building edge

Dust into the wall joints and the dry voids, and a targeted band tight against the foundation and around openings, because the material holds longer on a porous surface than on tile.
3
Close the ways in and remove the prey

A sweep under the doors, sealing where air-conditioning and drain pipes pass through, mesh over openings, and treatment of the cockroaches and insects it feeds on, so the reason to come in goes with them.
4
The follow-up visit

A scorpion can sit in its harbourage for weeks without moving, so the first pass does not always reach it. We come back to refresh the perimeter band and check what has appeared since.

What scorpion control includes

A night survey with an ultraviolet lamp

A walk of the perimeter after dark that fixes the harbourage and the entry routes before anything is applied.
Targeted perimeter and joint treatment

A band against the foundation, plus wall joints and cracks, never open floors or where children play.
Sealing openings and pipe entries

Drain openings, the points where air-conditioning pipes pass through, and mesh on shafts, which are the routes actually used.
Treating what it feeds on

Placed bait for cockroaches at entrances and service areas, because cutting the food supply reduces visits more than repeating a spray.
Aftercare instructions

What to lift out of the yard, where to move the outside light, and the ventilation time for your situation, which we give you on site.
A scheduled follow-up

A set date after the first treatment, a refreshed perimeter band and a check of anything new around it.

The character of Rai Adhakhir

Apartment district: residential blocks, repeated floors and shared entrances

In apartment quarters, scorpions travel through shared internal joints and party walls seeking insects, not the exterior walls of villas. This makes the work focus on internal and common points rather than the perimeter.

Questions about this district

Why do scorpions climb between the floors of apartment blocks?

The warmth radiating from homes and the small insects attracted to the lights encourage scorpions to ascend through cracks and joints. In stacked buildings, party walls offer a direct route through the structure from floor to floor.

Will the treatment damage the paintwork or insulation between units?

We use formulations safe for internal joints that need no removal and do not mark the finishes. Sealing is done with materials that are safe for residents and the building itself.

What part does dampness play in the floor joints?

Moisture in the seams between storeys shelters and feeds the small insects that attract scorpions. Treatment focuses on drying these areas and sealing them against future entry.

Can scorpions cross over from a neighbour's flat?

Yes, shared walls allow scorpion movement between flats. Full treatment requires coordination with residents to address the common points of entry.

How many treatment points does a single apartment building require?

This varies with building size and storey count, but each floor junction is assessed separately, with focus on the spots where internal walls meet the outer skin.

Do residents have to leave their flats during the treatment?

Treatment of external and party wall seams often proceeds without asking residents to leave. Shared internal zones may need prior coordination.

How much does scorpion control in Rai Adhakhir cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Rai Adhakhir.