A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Al Huda Jeddah

Al Huda is a dense residential district in south Jeddah formerly known as Al Tahlawi. Three-storey apartment buildings set the pattern and new villas are rising on vacant plots. Tanks here are mostly modern but the main pipe network supplying the district is old. A simple test closing the valves shows whether the leak is from the tank itself or the pipes.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Al Huda

Most apartment buildings were built in the 1980s and 1990s, and relatively modern tanks rarely leak, but the district's main pipe network is old and worn. The method is set out in full on Tank leak repair in detail.

The first reason

Three-storey blocks with rooftop tanks

The standard pattern in Al Huda is three-storey blocks each with its own rooftop tank. The tanks are relatively modern but internal pipes may be old and leak at joints.

The second reason

New villas with complex tank systems

New villas on vacant plots have more complex tanks and pump systems. Leaks here may come from new pipe faults or improper joint installation.

The third reason

Old main distribution network serving the district

The main distribution pipes serving the district run underground and are very old. Leaks affecting multiple households point to a crack in the main network.

The character of Al Huda

Apartment district: residential blocks, repeated floors and shared entrances

Al Huda has three-storey blocks and new villas, so tanks are mixed in type and age. Apartment blocks have standardised older tanks, while new villas have modern tanks with complex pump systems. Repair depends on property type, tank age and pipe network.

Before treatment

Where the water leaves decides how it is repaired

A residential district in south Jeddah east of Al Sanabil, south of Al Ajawid and northeast of Al Taawun, with Al Laith Road near its western edge.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

The float valve may leak slowly from misalignment or seal defect.

A fine crack running across a concrete surface

The kind of crack

The outlet and drain valve leaks at old joint connections in the internal pipework.

The corner where a concrete floor meets a wall

The wall to floor junction

Tank wall cracks are small and usually appear on the sides or at pipe joint entry points.

Water pipes passing through a concrete wall

Pipe entries

Pipes buried under ground may leak at routine joints or from natural ground settling.

A blistered and peeling layer on a concrete surface

The condition of the old lining

Moisture around the tank points to a leak from below or from pipe joint failure.

A white plastic water tank standing outside

What the tank is made of

Leaking increases in summer when heat is high and pipes expand.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

What is different about South Sub-Municipality

The South sub municipality runs from the edge of Old Makkah Road down to Al Khumrah and the southern corniche. Dense residential districts sit beside new subdivisions such as Al Sanabil and Al Taawun, warehouse fringes such as Al Saruriyah and Al Sarawat, and an old seaside settlement at Al Quzayn. Open stormwater channels cross the housing, and the warehouses, the vegetable and livestock markets and the nearby Islamic Port and Industrial City give pests shelter, food and year round humidity. Pressure is greatest in the older quarters, where drainage networks are ageing.

Questions about this district

Why do new tanks leak more often than the main pipes?

Modern tanks leak at joints or from manufacturing defects. Main pipes leak very slowly but are known for shared issues.

Does leaking from internal building pipes differ from main network leaks?

Yes. Internal pipes leak at joints and bends. Main pipes leak from long cracks and sustained pressure.

How often should tanks be inspected in Al Huda to prevent leaks?

A simple check every six months is enough. If the bill rises suddenly an urgent inspection is needed.

Are modern plastic tanks as durable as concrete ones?

Modern plastic tanks are safe but more prone to thermal cracks. Concrete is stronger but may leak from corrosion over time.

If the bill is high is the leak in my tank or the street pipe?

Check your house first by closing the valves. If the level keeps falling the problem is yours. If it stops the main may be at fault.

Does installing a new tank stop leaks from the main pipes?

No. A new tank stops only tank leaks. Main pipe leaks need separate repair from the municipality or contractor.

How much does tank leak repair in Al Huda cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Huda.

Nearby districts we cover

Other services in Al Huda

Other services we provide to residents of Al Huda.

All services

Need tank leak repair in Al Huda? Tell us what you saw and we will tell you what it needs

We reach Al Huda at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp