A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Al Jumayzah Makkah

Al Jumayzah is a small dense district near the Grand Mosque with numerous apartment blocks and small hotels receiving Umrah visitors. Tanks here face constant pressure from heavy use and saline water, and leaks appear rapidly on external walls and foundations.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Al Jumayzah

Residential buildings and hotels in the district rely on overhead and ground tanks, and water demand is very high especially during Hajj and Umrah seasons. The method is set out in full on Tank leak repair in detail.

The first reason

Heavy use and constant pressure on tanks

Al Jumayzah hotels serve Umrah pilgrims year-round and daily water use is very high. Tanks face continuous stress from repeated fill and drain cycles every few hours.

The second reason

Saline water and heavy minerals in the network

The water network in Al Jumayzah is relatively old and contains heavy minerals and salt. This accelerates corrosion of tank walls and metal pipes.

The third reason

Overhead tanks on roofs in tight building spaces

Hotels and apartment blocks have tanks on roofs in confined areas. Leaks quickly reach external walls and apartments below them.

Al Jumayzah on the map

Al Jumayzah sits about 1.5 km from Al Maabdah and about 1.5 km from Rai Adhakhir.

Open in Google Maps
Before treatment

Where the water leaves decides how it is repaired

A small densely built quarter near the Grand Mosque along Al Hajoun Street and Al Masjid Al Haram Road, named after the ancient sycamore fig tree where residents once gathered.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

The float valve and outlet check comes first because valve leakage can mimic tank body leaks.

A fine crack running across a concrete surface

The kind of crack

Measuring level drop tells us whether the leak is in the tank body or in the pipe network and connections.

The corner where a concrete floor meets a wall

The wall to floor junction

Inspecting cracks and corrosion on tank walls focuses on areas bearing the most pressure.

Water pipes passing through a concrete wall

Pipe entries

Checking external wall moisture and sediment traces identifies the leak location exactly.

A blistered and peeling layer on a concrete surface

The condition of the old lining

Inspecting the pipe entry point and connections where the tank joins the water network, as leaks often form there.

A white plastic water tank standing outside

What the tank is made of

Checking tank wall thickness and surface rust determines whether repair or replacement is necessary.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

The character of Al Jumayzah

Apartment district: residential blocks, repeated floors and shared entrances

Al Jumayzah is a dense residential quarter for pilgrims, and tanks here are typically communal for apartment buildings or small hotels. Repair requires permission from the building owner or hotel manager and work must be scheduled to avoid disrupting water supply to residents or guests.

Questions about this district

How do we tell the difference between a tank leak and a pipe leak?

We close the float valve and outlet and watch the level. If it falls, the leak is in the tank itself. If it stays level, the problem is in the pipe network.

Should old tanks in older hotels be replaced?

Not always. If the leak is at one point or at a pipe entry, repair and sealing are enough. Replacement is only needed if rust is widespread across all walls.

Why do leaks happen quickly in old tanks here?

Saline water, heavy use and high heat accelerate corrosion. Heavy minerals in the water react with old metal tank walls.

Does cleaning the tank alone stop the leak?

No, cleaning removes deposits only. The leak comes from a crack or worn spot in the wall, and repair must address the crack itself before any lining.

Does tank lining stop all leaks?

Lining prevents leaks from the inside surface only. If the crack is in the tank wall, lining alone is not enough; the crack must be repaired first.

How often should tanks in high-use hotels be inspected?

At least once every three months, especially during Hajj and Umrah seasons. Heavy use means faster wear.

How much does tank leak repair in Al Jumayzah cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Jumayzah.

Nearby districts we cover

Other services in Al Jumayzah

Other services we provide to residents of Al Jumayzah.

All services

Need tank leak repair in Al Jumayzah? Tell us what you saw and we will tell you what it needs

We reach Al Jumayzah at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp