A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Rai Adhakhir Makkah

Rai Adhakhir is a hillside district on steep slopes north-east of the Grand Mosque, with apartment blocks built in terraces on the slopes. Tanks here face extra pressure from continuous pumping at high elevation, and leaks run down the hillside walls to apartments below.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Rai Adhakhir

Buildings are constructed on steep gradients and overhead tanks sit on very elevated roofs. Continuous pumping to reach upper floors increases pressure on tank walls significantly. The method is set out in full on our Tank leak repair service.

The first reason

Continuous pumping and high pressure in elevated tanks

Tanks in Rai Adhakhir are positioned at the top of the slope to supply lower apartments. Pumping runs constantly and pressure on tank walls is very high, causing cracks.

The second reason

Leaks run down through external hillside walls

External walls of buildings are tied to the rock and hillside soil. A tank leak runs down through cracks and voids in the walls directly into lower apartments.

The third reason

High moisture and seepage from the slope

The hillside retains high moisture especially after rain. Groundwater and seepage from the slope increases pressure on tanks and foundations.

Landmarks of Rai Adhakhir

Access to tanks in Rai Adhakhir runs via Al Ijabah Street with Al Ijabah Mosque as the main landmark, and the climbing streets from Al Shisha and Al Maabdah define the district boundary.

  • Al Ijabah Mosque
  • Al Ijabah Street
  • Al Fahd Medical Complex
  • Al Hajj Street
  • Rai Al Hadadah
Before treatment

Where the water leaves decides how it is repaired

A hillside district north-east of the Grand Mosque on a mountain pass, its streets climbing from Al Shisha and Al Maabdah toward Al Khansa. Al Ijabah Mosque on Al Ijabah Street is its best-known landmark and terraced apartment blocks and a small medical complex cover the slopes.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

Measuring tank pressure comes first to check whether continuous pumping at height is causing cracks.

A fine crack running across a concrete surface

The kind of crack

Checking the level with float valve and outlet closed tells us if the leak is in the tank or the network.

The corner where a concrete floor meets a wall

The wall to floor junction

Inspecting cracks and weakness in the external tank walls, especially on the hillside face.

Water pipes passing through a concrete wall

Pipe entries

Checking moisture on the building's external walls traces how water runs down to lower apartments.

A blistered and peeling layer on a concrete surface

The condition of the old lining

Inspecting foundations and soil around the tank to check for seepage and groundwater pressure.

A white plastic water tank standing outside

What the tank is made of

Checking the condition of pipe connections and valves that bear the high pumping pressure.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

What is different about Al Maabdah Sub-Municipality

Al Maabdah sub municipality climbs from Al Abtah and Al Jumayzah beside the Al Mualla cemetery up through Al Khansa and Rai Adhakhir to Al Adl, Jabal Al Nour, Wadi Jaleel and Qurtubah on the outer ring roads. It mixes hotels and pilgrim housing near the Grand Mosque with old popular houses on hillside passes, new housing schemes on valley floors that carry flash floods after rain, and industrial plots, workshops and warehouses along Al Hajj Street in Qurtubah. Street widening and expropriation leave partly demolished frontages in Al Khansa.

Questions about this district

Why do overhead tanks in hill areas leak more often?

Continuous pumping from the slope base to the top increases pressure on tank walls. Height and pressure cause cracks quickly.

Does a tank leak in Rai Adhakhir affect lower apartments directly?

Yes, water runs directly down through external walls and weak foundations to apartments below.

How often should tanks on steep slopes be inspected?

At least once every two months. High pressure and continuous pumping cause faster wear than flat areas.

Does resetting tank pressure stop the leak?

It may reduce it temporarily but won't stop it. If there is a crack in the tank wall, the crack itself must be repaired.

How do we handle leaks running from the tank to lower apartments?

We locate the exact leak point, repair the crack or wear in the tank wall, then ensure the building's external wall is sealed from outside.

Does moisture from the slope affect how fast a leak spreads?

Yes, high slope moisture and seepage accelerate tank wall corrosion and the extra pressure worsens the leak.

How much does tank leak repair in Rai Adhakhir cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Rai Adhakhir.

Nearby districts we cover

Other services in Rai Adhakhir

Other services we provide to residents of Rai Adhakhir.

All services

Need tank leak repair in Rai Adhakhir? Tell us what you saw and we will tell you what it needs

We reach Rai Adhakhir at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp