Water tank cleaning in Al Ghazzah Al Jadid, Makkah

Potable-rated materials

Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
You get the downtime first

How many hours the tank is out of service, told before we start rather than after we finish.
A first-draw flush

We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
Ground and roof tanks

Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Al Ghazzah Al Jadid

Water in Al Ghazzah Al Jadid carries heavy silt, especially in the hours after rain, a pattern far heavier than in districts far from main roads. The method is set out in full on the full Water tank cleaning page.

The first reason

Al Laith Road silt and volume

Al Ghazzah Al Jadid sits on Al Laith Road itself, where traffic and excavation lift heavy silt into the air. Your tanks fill with thick brown layers that have no equivalent in distant neighbourhoods. The sediment is dense and compacts on the floor.

The second reason

New schemes and absent filtration

New projects mean basic or missing filters in early schemes. First cleaning here is deeper and sediment loads are heavier than anywhere else. Water pressure is unfiltered at source.

The third reason

Seasonal rain and road runoff

The Fourth Ring Road collects surface water after heavy rain and channels it across Al Laith. Your water may become dark brown for hours after a downpour. Post rain cleaning is essential here more than in other districts.

Al Ghazzah Al Jadid on the map

Al Ghazzah Al Jadid sits about 3.5 km from Harat Al Bab Al Jadid and about 6.5 km from Al Shubaikah Al Jadid.

Open in Google Maps

Before treatment

The condition of the tank decides the method

A new district on the Al Laith road between the Fourth Ring Road and Al Ukayshiyah, with active development of residential and commercial plots creating high volumes of dust and silt.

Fine brown sediment beneath shallow water

The layer on the floor

Heavy silt falls to the tank floor quickly here, and the layer is denser than in other areas, requiring full drainage rather than routine scrubbing to lift it properly.

Light and algae

Algae is rare in Al Ghazzah Al Jadid because silt covers the walls and blocks light. Cleaning reveals old algae growth buried under heavy deposits.

A damp concrete wall carrying a dark deposit

The deposit on the wall

The wall layer is dark brown heavy silt that does not release easily. High pressure washing is necessary, and new tanks here are strong enough to take it well.

A concrete surface with a fine hairline crack

The lining and hairline cracks

Hairline cracks are rare in new tanks, but vibration from surrounding construction may open small cracks around corners. Post rain inspection is safer than relying on tank strength alone.

The lid of a water tank on a building roof

The lid and the access hatch

Covers and access hatches are new and simple to clean, but silt seeps in around seals because open roads and construction blast dust constantly. Airtight seals matter much more here.

A plastic pipe leaving the exterior wall of a building

The vent and the overflow pipe

Ventilation openings and overflow pipes carry heavy silt during and after rain events. Strong filtration on the vent is essential, and the overflow may need separate cleaning when road conditions worsen.

How we work

1
Inspect before the drain

Tank type and material, the condition of the lining, the depth of the sediment, the lid and the vent, and where the drained water will go. We agree the window without supply before anything is opened.
2
Drain, then lift the sludge

The water leaves through the outlet, then the layer beneath it is taken out by hand and by suction. That layer is the reason for the visit, not the water that ran out ahead of it.
3
High pressure wash

Walls, floor and the joint where they meet, with a brush wherever the film resists, then the wash water is taken out completely so nothing we lifted settles again.
4
Disinfect and put back in service

Disinfectant over every internal surface, left for its contact time and then rinsed out, followed by the refill, a first draw off at the taps, and a report on what was inside the tank.

What water tank cleaning includes

An inspection before the valve

Tank type, lining condition, depth of sediment, lid and vent, recorded before any water leaves.
Full drain and sediment removal

The water through the outlet, and the layer below it by hand and by suction until the floor itself is showing.
Pressure washing walls and floor

High pressure across the surfaces and corners, and a brush on anything water alone will not lift.
Disinfection after the wash

A disinfectant intended for drinking water tanks, named to you before it is used, left for its contact time and then rinsed out.
Refill and the first draw off

We refill, run the taps so the new water moves through the pipework, and tell you when it is ready to use.
A report and the next date

What was inside the tank, anything on the lid or the lining that needs repair, and a sensible date for the next clean.

Landmarks of Al Ghazzah Al Jadid

Al Ghazzah Al Jadid spreads along Al Laith Road between the Fourth Ring Road and Ahmad Al Barqi Street. Most tank access routes run through Ahmad Al Barqi Street which divides the scheme, and direct proximity to Al Laith Road is the main factor that sets silt volume in your tank apart.

Al Laith Road
Fourth Ring Road
Ahmad Al Barqi Street

Questions about this district

New house water is very cloudy with silt hours after the rain stops here?

Al Ghazzah Al Jadid is on Al Laith Road where rain lifts silt from open roads and surrounding excavations. Water may run dark brown for hours. Cleaning after heavy rain events is wiser than waiting and hoping it clears.

Is a tank in Al Ghazzah Al Jadid more prone to silt than other districts?

Yes. The road location and new scheme status means far heavier silt volume. Tanks here need strong filters or continuous monitoring because sediment loads are not typical.

First water from the tap at move in was extremely cloudy with silt particles?

New schemes lack strong filters or filters are already compromised. First fill carries heavy silt, and draining the initial batch then cleaning is essential, not optional.

How many times yearly should a tank be cleaned in Al Ghazzah Al Jadid?

Heavy silt from the road and construction means cleaning every four months is better than longer gaps. Sediment returns faster than you would expect from living in an older district.

Does active construction around the new tank damage it when first installed?

Excavation and building vibrations near a tank can produce small cracks. Inspection after the first heavy rain or after nearby digging is safer than assuming it will be fine.

Water holds dark brown particles even weeks after tank cleaning was done?

Silt in Al Ghazzah Al Jadid is dense and stays suspended in water longer than lighter dust elsewhere. Repeated cleaning and extra filters are necessary to improve clarity for longer periods.

How much does water tank cleaning in Al Ghazzah Al Jadid cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Ghazzah Al Jadid.