Tank leak repair in Al Ghazzah Al Jadid Makkah
Al Ghazzah Al Jadid is a new district in the south west of the city where the Fourth Ring Road meets Al Laith Road. Houses and shops here are newly built and tanks are new, but the inlet and outlet pipes need careful monitoring. The leak may be in the tank itself or in buried pipes running beneath shifting sand.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Ghazzah Al Jadid
Buildings and tanks are newly constructed and the soil is light sand; buried pipes may move slightly from ongoing construction and ground settlement. The method is set out in full on what Tank leak repair involves.
New tanks and new inlet pipes
The tanks here are newly made and the pipes running from the meter to the tank are newly installed. The leak often occurs at the point where the pipe meets the tank wall or at welded joints that are still settling.
Sandy soil and shallow foundations
The soil is light sand and concrete bases for new houses are relatively shallow. Buried pipes may shift slightly or settle when moisture retreats during the dry season.
Exposed external pipe system prone to thermal stress
High summer temperatures cause thermal expansion in plastic and metal pipes. Outdoor shutoff valves and joints experience pressure that can cause slow leaks.
The character of Al Ghazzah Al Jadid
New development: ongoing construction and vacant plots between the homes
A new district means tanks and pipes are newly installed with new materials. But shallow foundations and sandy soil mean buried pipes face constant pressure from sand and heat. Treatment focuses on checking joints and valves first before any draining.
Where the water leaves decides how it is repaired
A new district from the Crown Prince schemes in the south west, a mix of houses and shops on Al Laith Road near the Fourth Ring junction, bordered by Ahmad Al Barqi Street and Al Ukayshiyah.
Damp and salt on the outside wall
The first check focuses on the float valve, external pipes and recently welded joints.
The kind of crack
The pipe entry point into the tank is the most common leak site in new tanks.
The wall to floor junction
Base cracks are rare in new tanks but weak joints are very common.
Pipe entries
Moisture in the sand around the tank may indicate an external leak from buried pipes.
The condition of the old lining
Tank position relative to the foundation and surrounding sand must be carefully checked to distinguish internal from external leaks.
What the tank is made of
Slow, steady water level drop indicates a steady leak in the tank or outlet pipe.
How we work
-
1
Inspect and locate the leak
We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.
-
2
Drain, clean and dry
We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.
-
3
Repair the cracks and the entries
We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.
-
4
Refill, test, then sterilise
We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.
What tank leak repair includes
-
A marked level test
A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.
-
Draining and sediment removal
Water and silt out of the base, so the floor and the walls can be seen as they really are.
-
Pressure wash and dry back
The weak layer and the dust come off, because a repair only holds on sound concrete.
-
Cracks opened and filled
The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.
-
Refill and a recorded test
We refill, read the level again and write the reading down, so the result is not a matter of opinion.
-
Sterilised and back in service
A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.
What is different about South Makkah Sub-Municipality
South Makkah sub municipality is the belt of Crown Prince schemes south of Al Ukayshiyah, along the Al Laith road and the extension of Ibrahim Al Khalil Road to the Fifth Ring Road and the Non Muslims bypass. Most of it is still bare: granted plots awaiting houses, new villas standing alone, open building sites and unfinished paving and drainage. Wadi Uranah and its tributaries cross the low ground and hold water after rain, hills close it in, and rodents, reptiles and scorpions shelter in stacked materials and foundation pits before the neighbourhoods fill up.
Questions about this district
How do we tell a tank leak from a pipe leak in a new district?
We close the float valve and outlet and watch the level. If water drops from the tank alone, the leak is in the tank. If it does not drop, the leak is in internal or buried pipes.
Are slow leaks common in new tanks?
Yes. Slow leaks are common in new tanks due to welded joints still settling or small cracks forming in the base.
Why are buried pipes in Al Ghazzah Al Jadid prone to leaking?
Light sand provides unstable support and minor ground movement from ongoing construction can compromise pipe integrity.
Is surface sealing enough for a leaking tank or must it be drained and dried?
Surface sealing is temporary only. The tank must be fully drained, dried and cleaned before cracks are repaired; sealing comes after repair, never instead.
Does internal coating prevent leaks?
Coating stops leaks only briefly. If cracks exist, they must be repaired first, then coating is applied afterwards.
How long does repair take if the leak is in the pipes?
If the leak is in simple external pipes, repair may not need full drainage. If the pipes are in the foundation, partial drainage may be needed.
How much does tank leak repair in Al Ghazzah Al Jadid cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Ghazzah Al Jadid.
Nearby districts we cover
Other services in Al Ghazzah Al Jadid
Other services we provide to residents of Al Ghazzah Al Jadid.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sterilization
-
Water tanks
Water tank sealing
-
Residential
Cockroach control
Need tank leak repair in Al Ghazzah Al Jadid? Tell us what you saw and we will tell you what it needs
We reach Al Ghazzah Al Jadid at a time we agree, and you get the full cost before we start.