Water tank sterilization in Al Sabil Jeddah
Al Sabil is an old inner quarter between King Fahd Road and Old Makkah Road, with a mix of new and old cramped apartment buildings. Tanks in these mixed structures hold sediment from old foundations and polluted soil, and restaurants and shops consume water heavily. Sterilization requires deep washing to remove organic sediment and dirt, and sterilization of long water lines feeding shops and restaurants.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Sabil
Old and new buildings are mixed throughout Al Sabil; tanks vary greatly in age and condition, some on high roofs and others in tight basement spaces. The method is set out in full on how we approach Water tank sterilization.
Mix of old and new tanks
The quarter contains buildings from different eras, so some tanks are relatively new while others are very old. Old tanks contain rust and sediment; newer plastic tanks may be clean externally but contaminated inside. Sterilization must account for each tank's age and material.
Narrow lanes and difficult tank access
The quarter divides into very narrow lanes and roof access requires climbing many stairs. Some tanks sit in tight basement spaces under ground floors, making cleaning and sterilization difficult.
Restaurants and shops with high water demand
Al Sabil has many restaurants and shops around the old Sabil market. Water demand is high, and long lines from the tank to outlets allow bacterial growth time. Contaminated water may compromise food and drink safety.
Landmarks of Al Sabil
Access to Al Sabil runs via King Fahd Road and Old Makkah Road as main axes, with the old Sabil market and Khuzam Palace building as nearby landmarks.
- Old Makkah Road
- King Khalid Street
- Al Makhzoumi Street
- Bashar ibn Burd Street
- Bahlas Mosque
What we read inside the tank before anything starts
An old inner district between King Fahd Road and Old Makkah Road, with King Khalid Street to the south and east and Al Makhzoumi Street to the west. Older and newer apartment buildings stand side by side in narrow lanes, shops and eateries cluster around the old Sabil market, and Khuzam Palace lies just beyond the eastern edge.
Sediment on the floor
Bacteria multiply in long lines from the tank to restaurants and shops, especially during night stagnation.
The slime film on the wall
Algae and fungi form in new plastic tanks if exposed to light; old metal tanks contain rust deposits.
Light and heat
Organic sediment from food and grease accumulates in lines to restaurants and requires strong sterilization.
The lining and any cracking
Moderate ambient humidity but long stagnant lines mean slow water movement, creating ideal conditions for bacterial and microbial growth.
The lid and the openings
Sediment collects around pipe joints and at the tank, and in tight basement tanks may be hard to reach.
What shows up at the tap
Cloudiness and turbidity appear especially in restaurants after heavy use periods, signalling sediment stirred up from the floor.
How we work
-
1
Inspect and record the condition
We open the hatch and work through what the tank is made of and how big it is, how deep the sediment lies, the state of the lining, whether the lid and the overflow seal, and whether there is a crack that has to be repaired before any sterilizing.
-
2
Drain and lift the sediment out
The water goes out, then the silt and sand are lifted off the floor by suction rather than pushed toward the outlet, because pushing them sends them into the house pipework and the heater.
-
3
High pressure wash
Walls, floor, corners and the area around the outlet, until the slime film is completely gone. This is the step that makes the sterilizing after it mean anything.
-
4
Sterilize, rinse, then return to service
The sterilizing agent goes onto the walls, the floor and the underside of the lid and is left for its contact time, then we rinse, refill and run the furthest tap until the whole line is clear.
What water tank sterilization includes
-
A recorded inspection
Material, capacity, sediment depth, the state of the lining, the lid and the overflow, all before any work begins.
-
Draining and sediment removal
The water out, and the silt and sand lifted off the floor instead of being pushed into the outlet and the house pipework.
-
High pressure washing
Walls, corners and around the outlet, until the biofilm that no disinfectant penetrates has gone.
-
Sterilizing the internal surfaces
A sterilizing agent meant for drinking water tanks, applied to the walls, the floor and the underside of the lid, and left for its contact time.
-
Line flush and aftercare
Rinse, refill and a flush from the furthest tap, when the water is usable again, and what to change in the filter afterwards.
-
The next cycle
We agree the right interval for your tank from how it is filled, how much sun it takes and the condition of the lid.
What is different about Al Balad Sub-Municipality
Al Balad sub municipality covers the historic core of Jeddah and the districts that first grew outside its wall. Its building stock is the oldest in the city: heritage stone houses and apartment blocks from past decades, threaded with hotels, shops and crowded popular markets around Bab Makkah, Bab Sharif and the Kandarah Souq. Nearness to the sea, the Islamic Port and the Arbaeen lagoon keeps humidity high all year, water and drainage networks are old, and narrow lanes, dense eateries and commercial storerooms put food and shelter within reach at every corner.
Questions about this district
Do old and new tanks need different sterilization methods?
Yes. Old metal tanks need heavy washing to remove rust; newer plastic tanks may need gentle washing but strong internal sterilization.
Why does restaurant water need frequent sterilization?
Restaurants use water heavily throughout the day, and long lines plus night stagnation allow bacteria to multiply. Contaminated water may create health risks.
Does difficult tank access affect sterilization quality?
Yes. Tanks in tight basement spaces are hard to clean fully. We may need specialist tools and different methods.
How often should tanks be sterilized in a quarter like Al Sabil?
At least twice yearly, especially if serving restaurants or shops. High consumption means faster contamination.
Can sediment from old foundations enter the tank?
Possibly. If the tank is near old foundations or polluted soil, dust and dirt particles may enter through small leaks.
Does sterilizing long lines take extra time?
Yes. Long lines from tank to outlets need thorough sterilization from the tank to the furthest tap, which may take many hours.
How much does water tank sterilization in Al Sabil cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Sabil.
Nearby districts we cover
Other services in Al Sabil
Other services we provide to residents of Al Sabil.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sealing
-
Water tanks
Tank leak repair
-
Residential
Cockroach control
Need water tank sterilization in Al Sabil? Tell us what you saw and we will tell you what it needs
We reach Al Sabil at a time we agree, and you get the full cost before we start.