A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Al Mudaa Al Jadid Makkah

Al Mudaa Al Jadid is a new district from the Crown Prince schemes south of Jeddah along the Ibrahim Al Khalil Road extension. The district contains newly built villas scattered across a wide, flat open land, and tanks both overhead and underground are newly installed. Wadi Uranah crosses the ground and Jabal Labanah rises to the north.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Al Mudaa Al Jadid

New villas are scattered across wide expanses of mixed sandy and clay soil; tanks are installed to modern standards. The method is set out in full on Tank leak repair in detail.

The first reason

New villas with large overhead tanks

The new villas have large overhead tanks and modern electric pumps. The pipes running from ground to overhead tank are long and steady pressure may cause leaks at weak points.

The second reason

Sandy clay soil and unstable ground

The soil is a mix of sand, clay and soft rock. Concrete foundations for villas and tanks may subside very slowly, causing minor cracks in the tanks over time.

The third reason

Long distances and extended pipework

Each villa sits on wide land and pipes run from ground tank to villa and may span several tens of metres. Long joints and extended runs are prone to thermal expansion and contraction.

Al Mudaa Al Jadid on the map

Al Mudaa Al Jadid sits about 2 km from Al Qararah Al Jadid and about 5.5 km from Shaab Amer Al Jadid.

Open in Google Maps
Before treatment

Where the water leaves decides how it is repaired

A new residential district from the Crown Prince schemes south of Al Ukayshiyah along the Ibrahim Al Khalil Road extension. Most land is empty and new villas are scattered. The district is bounded by Wadi Uranah on one side, the southern Haram boundary marker on another, and Jabal Labanah to the north.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

The first check focuses on the float valve, electric pump and pressure at distant joint points.

A fine crack running across a concrete surface

The kind of crack

The long pipe run from ground tank to overhead tank is the most likely leak site.

The corner where a concrete floor meets a wall

The wall to floor junction

Tank base cracks may emerge due to slow, persistent ground subsidence.

Water pipes passing through a concrete wall

Pipe entries

Moisture around the villa may indicate a leak in the long buried pipes.

A blistered and peeling layer on a concrete surface

The condition of the old lining

The overhead tank position and steady pump pressure may cause leaks in walls or the floor slab.

A white plastic water tank standing outside

What the tank is made of

Slow steady water level drop indicates a continuous leak in the tank or long pipes.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

The character of Al Mudaa Al Jadid

New development: ongoing construction and vacant plots between the homes

New villas on wide open land mean tanks are large and pipes are very long indeed. Sandy clay soil may subside very slowly, causing cracks. Treatment must account for constant pump pressure on long pipes, not just the tank itself.

Questions about this district

Should we expect leaks in new villa tanks?

They can occur due to pressure from long pipe runs and strong pumps. Small cracks may appear at weak points over time.

Why do long pipes from ground to overhead tank cause leaks?

Constant pump pressure and thermal stress create continuous strain on joints and pipes. Weak points may crack or weep slowly.

Does slow ground movement affect tanks here?

Yes. New foundations may subside very slowly. This subsidence causes hairline cracks that may not show up until months later.

How do we tell if the leak is in the tank or in the long pipes?

We close the float valve and outlets and watch. If water drops from the tank itself, the leak is there. If not, the leak is in the distant pipes.

Can we fix long pipes without draining the whole tank?

It may be possible if the leak is in outlet pipes. But if it is in pressure lines or inlet, we may need partial drainage.

Does quick patching or coating fix leaks caused by ground subsidence?

No. Quick patches are temporary only. If the ground is subsiding, cracks will return. The actual cracks must be repaired first, then coating applied afterwards.

How much does tank leak repair in Al Mudaa Al Jadid cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Mudaa Al Jadid.

Other services in Al Mudaa Al Jadid

Other services we provide to residents of Al Mudaa Al Jadid.

All services

Need tank leak repair in Al Mudaa Al Jadid? Tell us what you saw and we will tell you what it needs

We reach Al Mudaa Al Jadid at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp