A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Al Hamra Jeddah

Al Hamra is an upmarket district on the Red Sea shore with hotels, large residential buildings and luxury villas. Tanks here face very high water pressure and sea salt penetrates tank walls and metal pipes.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Al Hamra

Buildings in the district are relatively modern and tall, and both rooftop and ground tanks are exposed to sea salt and very high humidity from the water. The method is set out in full on how we approach Tank leak repair.

The first reason

Salt and humidity corrode metals rapidly

Sea salt enters the air and water and corrodes copper and steel pipes very fast. Seals and joints rust within months instead of years.

The second reason

Rooftop tanks on tall buildings

Rooftop tanks are directly exposed to sun, salt and winds from the sea. Cracks form rapidly and rust eats tank walls from outside and inside together.

The third reason

High pressure and salty water strain joints

Pressure here is very high and water contains salt, iron and calcium from the sea. Joints and flanges corrode and leak water rapidly.

Al Hamra on the map

Al Hamra sits about 3.5 km from Al Andalus and about 3.5 km from Mushrifah.

Open in Google Maps
Before treatment

Where the water leaves decides how it is repaired

An upmarket coastal district on the Red Sea waterfront between the Corniche, Madinah Road and the coastal promenade, with apartment buildings, hotels, spacious villas and upscale retail. It is bounded by Palestine Street to the south and Al Andalus to the north, and its waterfront faces the King Fahd Fountain.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

The float valve rusts quickly from sea salt and high humidity and does not close tightly.

A fine crack running across a concrete surface

The kind of crack

Copper and steel pipes corrode from salt, humidity and oxygen from the sea, and joints leak.

The corner where a concrete floor meets a wall

The wall to floor junction

Metal tank walls rust from outside due to salt and humidity and from inside due to water and sediment.

Water pipes passing through a concrete wall

Pipe entries

High humidity and salt from the sea cause seals and joints to fail very quickly.

A blistered and peeling layer on a concrete surface

The condition of the old lining

Tank floor collects salt, sand and mineral sediment and stagnant water causes bad smell.

A white plastic water tank standing outside

What the tank is made of

Joints, corners and pipe entry holes are the places where leaks start first in Al Hamra.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

The character of Al Hamra

Coastal area: high humidity and salt air through the year

Al Hamra is an upmarket coastal district with hotels, tall buildings and luxury villas. The harsh coastal environment means water tanks need high protection from salt and humidity. Repair must use salt-resistant materials and need much more frequent regular inspection.

Questions about this district

Does sea salt enter the fresh water tank?

The water itself usually stays fresh because the network is sealed. But salt corrodes pipes and joints from outside and inside together, so water quality falls.

Why do Al Hamra tanks leak faster than other areas?

Salt and humidity from the sea speed up corrosion greatly. Metal tanks and copper pipes rust within months, and fibreglass cracks from high pressure and heat.

Does cleaning the tank of salt deposits stop the leak?

Cleaning improves water quality. But if walls are corroded or joints are weak, leaks continue. Real repair means replacing weak pipes and sealing joints tightly.

How do we protect the tank from sea salt corrosion?

We use seals and pipes treated against salt and rust. Regular cleaning and external coating are important. Some new tanks are painted with salt-resistant paint.

Do hotels in Al Hamra have different tanks from villas?

Yes. Hotels need larger tanks and higher pressure to supply continuous water. Large tanks are more prone to cracks and leaks.

How often should the tank be inspected in a coastal district?

At least every three months. Salt, humidity and pressure accelerate corrosion and leaks can happen fast. Hotels need monthly inspection.

How much does tank leak repair in Al Hamra cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Hamra.

Nearby districts we cover

Other services in Al Hamra

Other services we provide to residents of Al Hamra.

All services

Need tank leak repair in Al Hamra? Tell us what you saw and we will tell you what it needs

We reach Al Hamra at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp