A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Al Hindawiyah Jeddah

Al Hindawiyah is a very old quarter beside Jeddah Islamic Port dating from the nineteenth century, divided by Al Dhahab Street separating the port-facing section from the crowded inland section filled with shops. Tanks here carry high water demand from shops, cafés and restaurants. We close the float and outlet valve and watch the level to establish whether the loss is in the tank itself or in old pipes threaded through the building.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Al Hindawiyah

Buildings here are over one hundred years old, and the original tanks and pipes are heavily corroded and very weak. The method is set out in full on the full Tank leak repair page.

The first reason

High water demand from shops, cafés and restaurants

Shops, cafés and restaurants below use very large volumes of water all day. Tanks are small and pressure is high; pipes cannot sustain continuous demand.

The second reason

Old pipes buried in stone walls

Copper and iron pipes were buried in stone walls over a hundred years ago. The walls have moved, pipes have cracked or bent, and connections have loosened from vibration and age.

The third reason

Salt and moisture from the very near port

The port is very close and salt and humidity are in the air every day. Foundations and tanks are exposed to salt and moisture constantly.

The character of Al Hindawiyah

Apartment district: residential blocks, repeated floors and shared entrances

The old crowded quarter means tanks and pipes are enclosed by building on all sides and difficult to access. Repair must account for the old tight building structure and pipes threaded through stone walls.

Before treatment

Where the water leaves decides how it is repaired

A cramped historic quarter beside Jeddah Islamic Port dating to the nineteenth century, divided by Al Dhahab Street and flanked by Port Street. Old apartment buildings sit above traditional shops and markets.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

Steel and copper tanks corrode from salt and moisture, with rust eating through metal from inside and outside.

A fine crack running across a concrete surface

The kind of crack

Pipe connections at valves, elbows and tank inlets corrode first from pressure, salt and age.

The corner where a concrete floor meets a wall

The wall to floor junction

Pipes in old stone walls have cracked from building movement, vibration and continuous pressure.

Water pipes passing through a concrete wall

Pipe entries

Moisture and salt from the port are present year-round and corrosion and rust never stop.

A blistered and peeling layer on a concrete surface

The condition of the old lining

Tanks are small and carry very high usage pressure from shops and residents, with cracks appearing from continuous strain.

A white plastic water tank standing outside

What the tank is made of

Slow leaks show as damp patches beneath the tank or water dripping from pipes, often accompanied by weak water pressure or repeated outages.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

What is different about Al Balad Sub-Municipality

Al Balad sub municipality covers the historic core of Jeddah and the districts that first grew outside its wall. Its building stock is the oldest in the city: heritage stone houses and apartment blocks from past decades, threaded with hotels, shops and crowded popular markets around Bab Makkah, Bab Sharif and the Kandarah Souq. Nearness to the sea, the Islamic Port and the Arbaeen lagoon keeps humidity high all year, water and drainage networks are old, and narrow lanes, dense eateries and commercial storerooms put food and shelter within reach at every corner.

Questions about this district

Why do tanks leak faster in Al Hindawiyah than in newer quarters?

Tanks and pipes are very old and carry very high usage pressure. Shops and residents use large volumes and pipes cannot sustain it.

Can pipes in old stone walls be repaired from inside?

If cracks are small, we inject a protective sealant from inside. But if pipes are completely broken, we may need new pipes run from outside.

Does water use by shops below affect water pressure in flats above?

Yes. If shops consume large volumes, upper flats may not get enough pressure. We may need a secondary tank or additional pump.

What is the difference between fixing a connection leak and replacing all old pipes?

Fixing a connection solves the immediate problem. Replacing all old pipes prevents future leaks and is the better long-term solution.

Can salt from the port enter the tank and water supply?

Salt in air and humidity accelerate rust on the tank from outside. If the tank is open or has gaps, salt may enter the water.

Does regular inspection prevent leaks in old quarters?

Regular inspection finds leaks early before they worsen. In Al Hindawiyah we recommend inspection every six months because usage is high and pipes are old.

How much does tank leak repair in Al Hindawiyah cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Hindawiyah.

Nearby districts we cover

Other services in Al Hindawiyah

Other services we provide to residents of Al Hindawiyah.

All services

Need tank leak repair in Al Hindawiyah? Tell us what you saw and we will tell you what it needs

We reach Al Hindawiyah at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp