Tank leak repair in Al Mursalat Makkah
Al Mursalat is a densely populated district east of the centre, lying between King Khalid Road and the waterfront. It holds apartment blocks and pilgrim hotels stacked above shops. Tanks here face constant pressure from heavy daily use and salt-laden air from the harbour, and seawater can reach buried pipe entries beneath floor slabs. A leak may originate in the tank itself or in the inlet and outlet pipes running beneath the buildings.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Mursalat
Buildings here are moderate in age and tanks face consistently high daily usage pressure from residents, hotels and shops combined. The method is set out in full on Tank leak repair in detail.
Residential blocks with pilgrim hotels and shops in one structure
Tanks in Al Mursalat supply water to many families, pilgrim hotels and commercial activity in the same building. Continuous use and high pressure speed up corrosion of the tank, metal pipes and connections.
Buried pipes run beneath floor slabs and corridors
Most inlet and outlet pipes lie buried under pavements and floor levels. If they leak, the problem may only surface when floor slabs become waterlogged or dampness appears in ceilings below.
Salt air from the harbour speeds corrosion
Al Mursalat lies close to the port and salt deposits on tank exteriors and metal piping. Oxidation happens faster here than in inland districts.
Al Mursalat on the map
Al Mursalat sits about 1 km from Al Jamiah and about 2.5 km from Al Sanabel.
Open in Google MapsWhere the water leaves decides how it is repaired
A dense apartment quarter east of Al Balad on King Khalid Road, containing residential blocks, pilgrim hotels, banks and commercial shops along Al Masjid Al Haram Road. It is bounded by the port to the west and the Fourth Ring Road to the east.
Damp and salt on the outside wall
Initial test: we close the float and outlet valves and wait an hour to establish whether water loss comes from the tank itself or from pipes outside it.
The kind of crack
Second test: we inspect pipes buried beneath floor slabs and corridors for moisture patches, bulges in the pavement or waterlogged walls below.
The wall to floor junction
Third test: we inspect inside the tank for cracks, weak spots or leaks around pipe entries where corrosion or poor sealing may occur.
Pipe entries
Fourth test: we check for rust and oxidation on the tank and metal pipes, especially due to salt-laden water near the port.
The condition of the old lining
Fifth test: we examine leaks around connections, fittings and metal clamps that bind the tank to pipes and supports.
What the tank is made of
Sixth test: we dry the tank completely before repair or lining, because moisture prevents repairs from bonding and lasting.
How we work
-
1
Inspect and locate the leak
We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.
-
2
Drain, clean and dry
We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.
-
3
Repair the cracks and the entries
We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.
-
4
Refill, test, then sterilise
We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.
What tank leak repair includes
-
A marked level test
A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.
-
Draining and sediment removal
Water and silt out of the base, so the floor and the walls can be seen as they really are.
-
Pressure wash and dry back
The weak layer and the dust come off, because a repair only holds on sound concrete.
-
Cracks opened and filled
The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.
-
Refill and a recorded test
We refill, read the level again and write the reading down, so the result is not a matter of opinion.
-
Sterilised and back in service
A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.
The character of Al Mursalat
Apartment district: residential blocks, repeated floors and shared entrances
Dense-use apartment buildings mean tanks supply water to families, hotels and shops simultaneously. Tanks are larger, piping more complex, and a leak may affect multiple floors. Treatment must account for the building's complex structure and the high pressure load on the tank.
Questions about this district
How do we tell if the leak is in the tank or the pipes?
We close the float valve and outlet valve and watch the water level fall. Continued loss means the tank leaks. If loss stops, the leak is outside the tank.
Do slow leaks need urgent repair?
Yes. Continuous moisture causes wood rot, metal rust and mould in ceilings and walls, affecting multiple floors.
Why do tanks corrode faster in Al Mursalat than other areas?
Proximity to the port, salt in the air, high humidity and intensive daily use from residents, hotels and shops together accelerate oxidation and corrosion.
Is draining and cleaning the tank enough or must we also repair the pipes?
If the leak is in the pipes, cleaning alone does not solve it. We must repair or replace the leaking sections.
How often does a tank in a building like this need cleaning?
In dense districts like this, once every one to two years depending on water quality and usage intensity.
Does paint solve salt corrosion?
Paint slows corrosion but does not stop it. If the tank is already rusted, we repair the rust first, then paint or line it.
How much does tank leak repair in Al Mursalat cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Mursalat.
Nearby districts we cover
Other services in Al Mursalat
Other services we provide to residents of Al Mursalat.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sterilization
-
Water tanks
Water tank sealing
-
Residential
Cockroach control
Need tank leak repair in Al Mursalat? Tell us what you saw and we will tell you what it needs
We reach Al Mursalat at a time we agree, and you get the full cost before we start.