Tank leak repair in Al Jamiah Makkah
Al Jamiah is a crowded quarter with dense apartment blocks and pilgrim hotels standing close together. Storage tanks here are mounted on rooftops and external walls, exposed to intense sun and extreme daily temperature swings. Leaks occur at joints and pipe entry points due to thermal stress and age.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Jamiah
Tanks here are elevated on tight rooftops and exposed to sharp daily temperature fluctuations caused by building density and intense summer heat. The method is set out in full on the full Tank leak repair page.
Tanks mounted on narrow rooftops
Residential buildings are dense and roof space is tight, so tanks sit directly beside each other on cramped rooftops. Joints, connections and wall seams between tanks face constant pressure from water and heat.
Intense heat and rapid thermal cycling
Sun beats directly on rooftops and the temperature swing between night and day is severe. Tank metal and pipe work expand and contract, causing cracks in welds and connections.
Pilgrim hotels consume very high water volumes
Hotels near the tanks use massive daily water volumes for showers, laundry and cleaning. This sustained high-pressure consumption puts continuous strain on tank walls and pipe networks.
The character of Al Jamiah
Apartment district: residential blocks, repeated floors and shared entrances
A densely built residential quarter means tanks are stacked on tight rooftops close together. Repair requires careful attention to connections between tanks and the pipes linking them, because thermal and mechanical pressure concentrates at these weak points.
Where the water leaves decides how it is repaired
A residential district east of Al Aziziyah and Al Mursalat, sitting on King Khalid Road and Al Masjid Al Haram Road. Apartment buildings are tightly packed alongside pilgrim hotels, with Makkah Mall, Alawi Tunsi Hospital and small parks serving residents.
Damp and salt on the outside wall
Rapid water level drop indicates a crack in the tank body or hole in internal pipe work.
The kind of crack
Moisture and cracking around the tank base shows leakage from the bottom or lower connections.
The wall to floor junction
Water stains and mineral deposits on the tank's outer wall pinpoint the exact leak location.
Pipe entries
Thermal stress and continuous expansion create strain on welds, connections and pipe entry points.
The condition of the old lining
The tank must be fully drained and dried before any repair because moisture prevents proper fixing and sealing.
What the tank is made of
Sealant coating is applied after complete repair to protect against heat, moisture and corrosion.
How we work
-
1
Inspect and locate the leak
We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.
-
2
Drain, clean and dry
We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.
-
3
Repair the cracks and the entries
We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.
-
4
Refill, test, then sterilise
We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.
What tank leak repair includes
-
A marked level test
A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.
-
Draining and sediment removal
Water and silt out of the base, so the floor and the walls can be seen as they really are.
-
Pressure wash and dry back
The weak layer and the dust come off, because a repair only holds on sound concrete.
-
Cracks opened and filled
The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.
-
Refill and a recorded test
We refill, read the level again and write the reading down, so the result is not a matter of opinion.
-
Sterilised and back in service
A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.
What is different about Al Aziziyah (Makkah) Sub-Municipality
Al Aziziyah sub municipality runs from the Bin Dawood markets to the Al Hada road and carries pilgrim traffic to Mina. Hotel towers and furnished apartment blocks fill and empty with the Hajj and Ramadan seasons, and the kitchens, restaurants and markets along Al Masjid Al Haram Road and King Abdulaziz Road leave food waste at every peak. Southwards the fabric loosens into villas and planned streets in An Naseem and Al Awali, then Al Abidiyah's campus and the old farms of Al Husayniyah, where Wadi Uranah holds water after rain and farm enclosures shelter rodents and reptiles.
Questions about this district
How do we know if the leak is in the tank itself and not the external pipes?
We close the float valve and outlet and monitor the water level. If it falls, the leak is in the tank body; if it holds steady, the problem lies in external plumbing.
Does a small leak in tank welds require full drainage?
Yes, because we completely dry the tank before repair and only apply sealant coating after the crack is mechanically fixed, never in place of it.
Why do leaks increase in summer specifically in Al Jamiah?
Intense heat causes tank metal and pipes to expand and contract, opening dormant cracks along joints and seams.
Does tank sealant coating alone stop a leak?
No. The sealant coating comes after mechanical repair of cracks and joints; it does not replace proper structural fixing.
Are tightly packed tanks on narrow rooftops more prone to leakage?
Yes. Pressure between tanks and slow building movement create stress on connections and pipe networks.
How often should a tank be inspected after repair?
We recommend checking annually before summer, because high heat may open new cracks around the new weld site.
How much does tank leak repair in Al Jamiah cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Jamiah.
Nearby districts we cover
Other services in Al Jamiah
Other services we provide to residents of Al Jamiah.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sterilization
-
Water tanks
Water tank sealing
-
Residential
Cockroach control
Need tank leak repair in Al Jamiah? Tell us what you saw and we will tell you what it needs
We reach Al Jamiah at a time we agree, and you get the full cost before we start.