A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Al Taysir Makkah

Al Taysir is a densely built residential district west of the Grand Mosque, its skyline marked by multi-storey apartments and hotel towers serving Umrah visitors. Rooftop tanks suffer accelerated corrosion from intense heat and salty water, and leaks originate either from the tank body itself or from inlet and outlet pipes.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Al Taysir

The buildings are relatively modern, mostly constructed in recent decades. Tanks sit on exposed rooftops under direct sun and high temperatures year-round. The method is set out in full on what Tank leak repair involves.

The first reason

Rooftop tanks corrode rapidly under constant heat

Unshaded roofs beneath direct sunlight cause fast deterioration of metal tanks. Daily thermal expansion and contraction creates fine cracks in the tank body.

The second reason

Inlet and outlet pipes face continuous water pressure

High-rise tanks subject pipes to constant hydrostatic pressure. Seals and older pipe entry points are the first to fail and leak.

The third reason

Apartment buildings need routine checks to prevent cascade damage

Continuous leaks spread water damage to units below the tank. Dense housing here means each leak affects dozens of residents at once.

The character of Al Taysir

Apartment district: residential blocks, repeated floors and shared entrances

Tall residential buildings here depend on reliable tanks because one leak affects dozens of flats at once. Treatment focuses on precise diagnosis of the leak source and thorough repair before lining, since lining alone cannot stop water entering through existing cracks.

Before treatment

Where the water leaves decides how it is repaired

A densely developed residential quarter west of the Sacred Mosque, bounded on the south by Umm Al Qura Road. It contains apartment blocks, hotel towers, retail shops and restaurants distributed along Al Taysir Street and connecting roads.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

Check the float valve and outlet first to determine whether the tank is holding or losing water quickly.

A fine crack running across a concrete surface

The kind of crack

Measure the rate of level fall after closing valves to reveal whether the leak is in the tank body or internal pipes.

The corner where a concrete floor meets a wall

The wall to floor junction

Inspect inlet, outlet and metal connectors for rust, cracks and weeping seals.

Water pipes passing through a concrete wall

Pipe entries

Rooftop tanks under heat need checking for fine cracks and surface corrosion.

A blistered and peeling layer on a concrete surface

The condition of the old lining

Cleaning sediment and salt deposits inside the tank precedes repair and reveals the true damage.

A white plastic water tank standing outside

What the tank is made of

Complete drying of the tank before crack repair or lining application ensures the fix sets properly.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

What is different about Al Ghazza Sub-Municipality

Al Ghazza sub municipality wraps around the north and west of the Grand Mosque, from Al Shamiyah, Al Qararah and Shaib Amir round to Jarwal and Al Taysir. Large tracts were cleared for the northern expansion and the Rua Al Haram scheme, leaving excavated ground and open construction sites beside ageing blocks that now serve as dense seasonal lodgings in Jarwal and Al Taysir. Old flood paths still fall from Jabal Qaiqaan and Jabal Khandamah towards the mosque, and markets and eateries crowd Al Masjid Al Haram Road and Umm Al Qura Road.

Questions about this district

How do we know if the leak is in the tank body or the pipes?

We close the float valve and outlet and watch the level. Slow fall means the tank body leaks; no fall means the problem is in the pipes.

Does lining the tank stop a leak immediately after application?

Lining goes on after a repair, not instead of one. The crack or pipe entry must be fixed first, then the lining seals the whole interior.

Why do Al Taysir tanks leak faster than tanks in other quarters?

Intense heat and direct sun on high rooftops accelerate corrosion of both metal and concrete tanks.

Is a leak from inlet pipes dangerous to the flats below?

Yes. Water can seep into units directly beneath the tank. Pipe inspection is critical.

How long does a crack repair last compared to full lining?

Crack repair is faster but temporary. Full lining offers longer protection but requires the damage to be fixed first.

Are concrete tanks better than metal ones in Al Taysir?

Concrete also corrodes from salty water and heat. Metal fails faster visually, but concrete needs careful inspection for internal cracks.

How much does tank leak repair in Al Taysir cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Taysir.

Other services in Al Taysir

Other services we provide to residents of Al Taysir.

All services

Need tank leak repair in Al Taysir? Tell us what you saw and we will tell you what it needs

We reach Al Taysir at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp