Tank leak repair in Badr Makkah
Badr is an emerging residential district on high and uneven ground between Al Usaylah and Al Khadra where the Fourth Ring Road meets King Faisal Road. Buildings here are new and tanks are modern but the rough terrain and incomplete services mean uneven pressure and tank leaks reveal installation defects early.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Badr
New residential buildings contain tanks of precast concrete and fibreglass. The high and uneven ground causes uneven building settlement. The method is set out in full on how we approach Tank leak repair.
Modern tanks on rough and unstable ground
Badr sits on very high and uneven terrain. Modern tanks are fixed to new roofs but foundations settle unevenly. Tension and twisting cause cracks at joints and welds to the tank.
Incomplete services and irregular pressure
The sub-municipality has not completed basic infrastructure and pressure in the network varies throughout the day. High pressure in morning and evening strains pipes and joints. Leaks appear during peak times.
New pipes and fittings with no pressure test
The district is very new and construction is ongoing. Pipes and fittings are installed quickly without real pressure testing. Joints may not seal properly and welds may be weak.
Badr on the map
Badr sits about 2.5 km from Usaylah and about 3 km from Khadra.
Open in Google MapsWhere the water leaves decides how it is repaired
A planned residential district on high western ground of the sub-municipality, next to Al Khadra and Al Usaylah where the Fourth Ring Road meets King Faisal Road. Scattered planned residential plots and new apartment buildings with incomplete services.
Damp and salt on the outside wall
Leaks from fine cracks in modern tanks happen slowly at first and grow with sustained pressure over time.
The kind of crack
Joints and welds between pipes and tank may be weak and leaks appear when pressure is high.
The wall to floor junction
Uneven building settlement causes longitudinal strain on pipes and longitudinal cracks in tank walls.
Pipe entries
Moisture and running water in the new network speeds corrosion and leaks in metal pipes.
The condition of the old lining
Sediment or buildup in new tank bottoms is rare but fine cracks beneath the surface need thorough pressure testing.
What the tank is made of
Slow leaks happen after pressure drops at night and residents notice falling tank level or dampness on roofs and walls.
How we work
-
1
Inspect and locate the leak
We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.
-
2
Drain, clean and dry
We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.
-
3
Repair the cracks and the entries
We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.
-
4
Refill, test, then sterilise
We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.
What tank leak repair includes
-
A marked level test
A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.
-
Draining and sediment removal
Water and silt out of the base, so the floor and the walls can be seen as they really are.
-
Pressure wash and dry back
The weak layer and the dust come off, because a repair only holds on sound concrete.
-
Cracks opened and filled
The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.
-
Refill and a recorded test
We refill, read the level again and write the reading down, so the result is not a matter of opinion.
-
Sterilised and back in service
A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.
The character of Badr
New development: ongoing construction and vacant plots between the homes
Badr is a new residential district on very high and rough ground. Buildings are new with tanks of the best concrete and fibreglass types, but rough terrain and uneven settlement cause strain on pipes and tanks. Repair requires understanding how settlement and instability affect pipe and joint integrity.
Questions about this district
Why is Badr more prone to tank leaks than older districts?
Badr is very rough and new ground with very new foundations and tanks that have not settled. Uneven settlement causes strain on pipes and joints.
Does irregular pressure in the network cause leaks?
Yes. High pressure reveals weak joints and untested modern pipes. Pressure dropping in the evening causes voids and additional strain.
How do we tell the difference between tank leak and distribution network leak in Badr?
We close the float valve and outlet valve and watch the level. If it falls, the leak is in the tank. If it stays level, the leak is in the external pipes.
Does pressure testing detect small leaks in new tanks?
Yes. Pressure testing finds any weak joint or small cracks. Slow leaks may not show in normal use but elevated pressure reveals them.
How do we repair cracks in modern tanks caused by uneven settlement?
We first test the tank under pressure to locate fine cracks. Then we drain, clean and dry it. Small cracks we inject with waterproof compound.
Does early repair of small leaks stop them growing into major ones?
Yes. Small leaks grow over time under sustained pressure. Early treatment stops them before major damage and further settlement.
How much does tank leak repair in Badr cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Badr.
Other services in Badr
Other services we provide to residents of Badr.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sterilization
-
Water tanks
Water tank sealing
-
Residential
Cockroach control
Need tank leak repair in Badr? Tell us what you saw and we will tell you what it needs
We reach Badr at a time we agree, and you get the full cost before we start.