A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Mughammas Makkah

Mughammas is an industrial storage zone on the eastern fringe beyond Al Sharai on the main road. Tanks here are large and heavy, serving warehouses and facilities. Seasonal flooding from Wadi Mughammas and wet soil exert outward pressure on buried tanks, and leaks appear from the sides and floor, not the top.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Mughammas

Warehouses and facilities here hold large volumes of water for operations and cooling. Underground tanks face seasonal groundwater pressure and periodic inundation. The method is set out in full on Tank leak repair in detail.

The first reason

Large buried tanks under heavy water load and seasonal floods

Warehouses contain large deep tanks below ground. Seasonal wadi floods raise the water table, and outward pressure on the tank walls causes leaks through the sides and floor.

The second reason

Wet soil and salt accelerate concrete deterioration

Soil here is always damp because the wadi is near and the water table is high. Salt and moisture erode concrete inside and out, and small cracks widen quickly.

The third reason

Heavy use and continuous pressure stress the tanks

Facilities fill and draw from tanks constantly. Sustained pressure, pump pulses and vibration from machinery fatigue the concrete and seams.

The character of Mughammas

Industrial area: workshops, warehouses and loading yards

An industrial storage zone means large heavy tanks buried underground. Outward pressure from floods and groundwater is entirely different from inward water pressure, so repair must account for structural pressures, not just cracks.

Before treatment

Where the water leaves decides how it is repaired

An industrial and storage zone on the far eastern fringe, open land and warehouses named after Wadi Al Mughammas, now called Wadi Al Akhdar. The district is bounded by Al Tariqi and Al Khatm hills and adjoins Al Rashidiyah and Al Kawthar; the wadi can flood in heavy rain.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

Horizontal and mesh cracks appear on tank floors due to outward pressure from groundwater and seasonal floods.

A fine crack running across a concrete surface

The kind of crack

Large inlet and outlet pipes leak at wall connection points under external pressure.

The corner where a concrete floor meets a wall

The wall to floor junction

Rapid loss occurs during floods when groundwater rises above the base level.

Water pipes passing through a concrete wall

Pipe entries

Persistent dampness and soil salt erode concrete from outside and inside simultaneously.

A blistered and peeling layer on a concrete surface

The condition of the old lining

Failure points lie in deep cracks and seams under external pressure; leaks develop from structural weak points.

A white plastic water tank standing outside

What the tank is made of

Seasonal loss increases during heavy rains and floods, and may persist after floodwaters recede if cracks are not repaired.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

What is different about Al Sharai Sub-Municipality

Al Sharai is the eastern growth front of Makkah along King Faisal Road and the Taif road. Settled quarters sit beside recently renamed schemes where plots are still vacant and buildings are going up, so construction sites, fill and open excavations lie next to occupied homes. Wadi channels such as Wadi Mudarraja, Wadi Al Sharai and Wadi Al Mughammas carry flash floods after rain and dry out to damp silt, while dust blows off the open hills. Roadside shops, restaurants and warehouses line the Taif road, and to the east the area shades into villages, palm farms and springs.

Questions about this district

Why are leaks in Mughammas more common from the bottom than the top?

Outward pressure from floods and groundwater presses on tank walls and floor. Bottom leaks are most common because pressure concentrates there.

Do seasonal floods cause new leaks each time?

Yes. Floods raise the water table and increase outward pressure. Any existing cracks widen further under added pressure.

Are large tanks harder to repair than small ones?

Yes. Large tanks need complete drainage and often lie deep below ground. Repair needs heavy equipment and longer timelines.

Does external pressure harm new tank lining?

Yes. Lining is applied inside and outward pressure pulls it from the walls. Structural repair must come first.

How do we protect tanks from future floods?

Sealing and regular maintenance help. But if external pressure is very high, we may need to raise the tank or build a protective wall.

Does slow leakage from a buried tank harm building stability?

Yes. Water weakens soil beneath the base and the tank may settle. This causes uneven subsidence of the warehouse.

How much does tank leak repair in Mughammas cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Mughammas.

Nearby districts we cover

Other services in Mughammas

Other services we provide to residents of Mughammas.

All services

Need tank leak repair in Mughammas? Tell us what you saw and we will tell you what it needs

We reach Mughammas at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp