Water tank sterilization in Al Furusiyah Jeddah
Al Furusiyah is a new district in northeast Jeddah around the equestrian club, and construction here is recent with villas and apartment blocks no more than a few years old. Water tanks here are new but sediment, silt and bacteria accumulate quickly due to the quality of supplied water and lack of regular maintenance. Periodic sterilization keeps the water clean and safe for families and apartment blocks.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Furusiyah
Villas and apartment blocks in the district are no more than four years old and tanks show no rust from age, but sediment, silt and sludge accumulate rapidly. The method is set out in full on the full Water tank sterilization page.
New tanks but supplied water carries sediment
The district is new and tanks are recently built, but water arriving from the network carries sand, silt and suspended matter. Sediment settles quickly to the bottom and forms a thick sludge layer.
Isolated villas and apartment blocks have different needs
Villas have smaller tanks and lower daily use, while dense apartment blocks have large tanks and high water flow rates. Each requires treatment scaled to size and usage pattern.
Ongoing construction brings dust and debris
The district is still under development and building projects continue. Dust, sand and fine particles blow into tanks via air gaps and open connections during construction work.
The character of Al Furusiyah
New development: ongoing construction and vacant plots between the homes
A new development district means villas and apartment blocks are modern and tanks were built to current standards, but supplied water carries sand and silt. Treatment focuses on methodical sediment and sludge removal, not rust or old-age damage as in historic quarters.
What we read inside the tank before anything starts
A new development district in northeast Jeddah centred on the equestrian club, bounded by Asfan Road to the north and Al Furusiyah Street to the west, next to Al Bashair and Al Rahmaniyah, containing modern villas, residential apartment blocks and wide construction areas still under development.
Sediment on the floor
Sand and silt settle to the tank bottom because supplied water carries suspended matter from the distribution network.
The slime film on the wall
Black oily sludge builds up on tank walls due to bacterial reactions and organic matter decay.
Light and heat
Contamination sources start in the network itself and enter via the tank inlet, with dust entering from air and ongoing building work.
The lining and any cracking
Moisture and still water in the tank create ideal conditions for bacteria and algae growth because it is sealed and dark.
The lid and the openings
Heavy silt and sludge settle to the tank base and floor, the hardest part to clean thoroughly.
What shows up at the tap
Signs of contamination show in discoloured water, odour or taste, but may not be obvious until the tank is opened.
How we work
-
1
Inspect and record the condition
We open the hatch and work through what the tank is made of and how big it is, how deep the sediment lies, the state of the lining, whether the lid and the overflow seal, and whether there is a crack that has to be repaired before any sterilizing.
-
2
Drain and lift the sediment out
The water goes out, then the silt and sand are lifted off the floor by suction rather than pushed toward the outlet, because pushing them sends them into the house pipework and the heater.
-
3
High pressure wash
Walls, floor, corners and the area around the outlet, until the slime film is completely gone. This is the step that makes the sterilizing after it mean anything.
-
4
Sterilize, rinse, then return to service
The sterilizing agent goes onto the walls, the floor and the underside of the lid and is left for its contact time, then we rinse, refill and run the furthest tap until the whole line is clear.
What water tank sterilization includes
-
A recorded inspection
Material, capacity, sediment depth, the state of the lining, the lid and the overflow, all before any work begins.
-
Draining and sediment removal
The water out, and the silt and sand lifted off the floor instead of being pushed into the outlet and the house pipework.
-
High pressure washing
Walls, corners and around the outlet, until the biofilm that no disinfectant penetrates has gone.
-
Sterilizing the internal surfaces
A sterilizing agent meant for drinking water tanks, applied to the walls, the floor and the underside of the lid, and left for its contact time.
-
Line flush and aftercare
Rinse, refill and a flush from the furthest tap, when the water is usable again, and what to change in the filter afterwards.
-
The next cycle
We agree the right interval for your tank from how it is filled, how much sun it takes and the condition of the lid.
What is different about Taybah Sub-Municipality
Taybah sub municipality covers the newly built districts of north east Jeddah along Al Haramain Road and Asfan Road. New villas and apartment buildings stand among vacant plots, building sites and half finished subdivisions. Al Hamdaniyah is the oldest and densest part with its markets and shops, while Al Furusiyah, Al Bashair, Al Rahmaniyah, Al Falah and Al Salihiyah are mostly recent. The ground is inland and away from the sea, dry and dusty, rest houses, camps and stables on the fringes draw flies and crawling insects, and constant digging and construction stirs rodents out of the empty plots.
Questions about this district
Why does a new tank need sterilization if it is just built?
The tank itself may be new but the supplied water carries sand and silt. Bacteria and sludge accumulate quickly even in new tanks.
Is sediment buildup less severe in new villas than old buildings?
Yes, but new villas in Al Furusiyah still face the problem because supplied water carries sand and suspended matter.
How often should a tank be sterilized in a new district like Al Furusiyah?
It depends on supplied water quality and consumption rate. In a new district with ongoing construction, sterilizing twice or three times yearly is appropriate.
Does ongoing construction affect tank water purity?
Yes greatly. Dust and debris from building sites enter the tank via air vents and connection points.
Do villa tanks need different treatment from apartment building tanks?
Yes. Villa tanks are smaller with lower flow rates, so treatment focuses on sludge and sediment. Apartment building tanks need stronger treatment due to high flow rates.
Is water safe immediately after sterilization or must we wait?
After sterilization and complete flushing from the furthest tap, water is safe to use immediately.
How much does water tank sterilization in Al Furusiyah cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Furusiyah.
Nearby districts we cover
Other services in Al Furusiyah
Other services we provide to residents of Al Furusiyah.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sealing
-
Water tanks
Tank leak repair
-
Residential
Cockroach control
Need water tank sterilization in Al Furusiyah? Tell us what you saw and we will tell you what it needs
We reach Al Furusiyah at a time we agree, and you get the full cost before we start.