Water tank sterilization in Al Salihiyah Jeddah
Al Salihiyah is a new district in north Jeddah where residential development has recently begun, with modern villas and apartment blocks spread across open ground with vacant plots between buildings. Water tanks in these new structures have not faced heavy use over time, yet static water and new heat conditions begin forming sediment and algae rapidly, even in recently installed tanks.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Salihiyah
New residents in Al Salihiyah have noticed water discolouration within weeks of occupancy, even when tanks are newly installed. The method is set out in full on the full Water tank sterilization page.
Modern villas with individual rooftop tanks
Each villa has a tank on the roof exposed directly to sun. New villas have not undergone routine cleaning cycles since installation.
New apartment blocks with shared rooftop tanks
New apartment blocks in Al Salihiyah have large shared tanks on roofs. These tanks serve dozens of units and water stands for extended periods.
Vacant plots around buildings and ongoing construction raise dust and moisture
The area remains under development and vacant plots surrounding buildings collect wind-blown dust. Moisture from surrounding areas and continuous construction affects water quality.
The character of Al Salihiyah
New development: ongoing construction and vacant plots between the homes
Al Salihiyah is newly developed and villas and apartments are newly built. New tanks require special attention to initial and routine sterilization. Treatment focuses on preventative sterilization rather than remedying problems accumulated over years.
What we read inside the tank before anything starts
A new district in north Jeddah between Al Hamdaniyah and Al Falah and Al Rahmaniyah, reached by Al Furusiyah Street, laid out as subdivisions of recent villas and apartments with vacant plots still lying between the buildings.
Sediment on the floor
Silt from municipal lines and construction deposits rapidly in new tanks; even recently flushed tanks accumulate sediment quickly.
The slime film on the wall
Biofilms form on tank walls within weeks if not sterilized, and green algae become visible under direct sunlight on villa roofs.
Light and heat
Supply lines from tank to taps need strong flushing after first fill because municipal lines may carry debris.
The lining and any cracking
High heat causes rapid growth of algae and bacteria in tanks exposed to direct sun on villa and apartment roofs.
The lid and the openings
New tank bases may hold manufacturing residue or transport contaminants; initial cleaning is essential.
What shows up at the tap
Flushing distribution lines from the furthest tap ensures removal of contaminants from both the new tank and municipal lines.
How we work
-
1
Inspect and record the condition
We open the hatch and work through what the tank is made of and how big it is, how deep the sediment lies, the state of the lining, whether the lid and the overflow seal, and whether there is a crack that has to be repaired before any sterilizing.
-
2
Drain and lift the sediment out
The water goes out, then the silt and sand are lifted off the floor by suction rather than pushed toward the outlet, because pushing them sends them into the house pipework and the heater.
-
3
High pressure wash
Walls, floor, corners and the area around the outlet, until the slime film is completely gone. This is the step that makes the sterilizing after it mean anything.
-
4
Sterilize, rinse, then return to service
The sterilizing agent goes onto the walls, the floor and the underside of the lid and is left for its contact time, then we rinse, refill and run the furthest tap until the whole line is clear.
What water tank sterilization includes
-
A recorded inspection
Material, capacity, sediment depth, the state of the lining, the lid and the overflow, all before any work begins.
-
Draining and sediment removal
The water out, and the silt and sand lifted off the floor instead of being pushed into the outlet and the house pipework.
-
High pressure washing
Walls, corners and around the outlet, until the biofilm that no disinfectant penetrates has gone.
-
Sterilizing the internal surfaces
A sterilizing agent meant for drinking water tanks, applied to the walls, the floor and the underside of the lid, and left for its contact time.
-
Line flush and aftercare
Rinse, refill and a flush from the furthest tap, when the water is usable again, and what to change in the filter afterwards.
-
The next cycle
We agree the right interval for your tank from how it is filled, how much sun it takes and the condition of the lid.
What is different about Taybah Sub-Municipality
Taybah sub municipality covers the newly built districts of north east Jeddah along Al Haramain Road and Asfan Road. New villas and apartment buildings stand among vacant plots, building sites and half finished subdivisions. Al Hamdaniyah is the oldest and densest part with its markets and shops, while Al Furusiyah, Al Bashair, Al Rahmaniyah, Al Falah and Al Salihiyah are mostly recent. The ground is inland and away from the sea, dry and dusty, rest houses, camps and stables on the fringes draw flies and crawling insects, and constant digging and construction stirs rodents out of the empty plots.
Questions about this district
Why do newly built villa tanks foul quickly even when newly installed?
Direct sun exposure heats the water and algae grow in warm water. New tanks have not undergone sterilization cycles since installation.
Does dust from vacant plots around villas enter the tank?
Dust can enter through vent openings. Under-construction areas release dust and moisture affecting water quality.
How often should tanks be sterilized in a new district like Al Salihiyah?
In a new district without heavy use history, once per year may suffice initially. After one or two years of occupancy, every six months may become necessary.
Does living in new Al Salihiyah mean cleaner water than older quarters?
Buildings are new but tanks foul at the same rate. Building age is not the only factor; heat and stagnant water are the cause.
Can we delay the first sterilization of a new tank?
No, sterilization must occur soon after installation. New tanks may contain manufacturing residue and transport contaminants.
Is flushing municipal supply lines necessary before filling a new tank?
Yes, municipal lines may hold silt and debris. Strong flushing is essential before filling a new tank in Al Salihiyah.
How much does water tank sterilization in Al Salihiyah cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Salihiyah.
Nearby districts we cover
Other services in Al Salihiyah
Other services we provide to residents of Al Salihiyah.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sealing
-
Water tanks
Tank leak repair
-
Residential
Cockroach control
Need water tank sterilization in Al Salihiyah? Tell us what you saw and we will tell you what it needs
We reach Al Salihiyah at a time we agree, and you get the full cost before we start.