Water tank sterilization in Taybah Jeddah
Taybah is a newly emerging district in north Jeddah beside Wadi Obhur, on Asfan Road between Al Sawari and Al Bashair and Al Asalah. Most villas are under construction and tanks are mounted at different building stages. Water here may contain construction and excavation sediment, and new tanks need careful sterilization before actual use.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Taybah
The district is still under development and core networks and tanks are at multiple installation stages. Active construction raises dust and sediment levels in the water supply. The method is set out in full on what Water tank sterilization involves.
Tanks installed at different construction stages
Villas in Taybah range from under-construction to occupied. Tanks are mounted before surrounding building finishes, exposing them to dust, moisture and debris from excavation.
Water contains construction sediment and excavation material
The water network is brand new and lines run through active building zones. Debris from excavation, concrete and iron enters tanks directly from the main line.
New tanks need initial sterilization before occupation
New owners often do not know that a new tank requires initial sterilization. First water may carry traces of lead from welding, oils from transport and manufacturing residue.
Taybah on the map
Taybah sits about 3.5 km from Al Firdaws and about 4 km from Al Sawari.
Open in Google MapsWhat we read inside the tank before anything starts
A newly developing district in north Jeddah near Wadi Obhur on Asfan Road, between Al Sawari to the west, Al Bashair to the east and Al Asalah to the south, laid out as land subdivisions with villas still under construction.
Sediment on the floor
Red and brown sediment from iron, rust and clay come from excavation and the new network around the building site.
The slime film on the wall
Dust and debris from neighbouring construction sites enter the tank through air vents and small cracks.
Light and heat
New lines contain many air pockets and unstable pressure from the central network still under maintenance.
The lining and any cracking
Tank moisture is very high because active construction raises ambient humidity and the tank may not be fully sealed.
The lid and the openings
Construction debris, concrete and iron settle rapidly at the base in the first weeks after installation.
What shows up at the tap
Early signs of contamination are metallic taste, sharp odour and visible cloudiness, appearing within days of first filling.
How we work
-
1
Inspect and record the condition
We open the hatch and work through what the tank is made of and how big it is, how deep the sediment lies, the state of the lining, whether the lid and the overflow seal, and whether there is a crack that has to be repaired before any sterilizing.
-
2
Drain and lift the sediment out
The water goes out, then the silt and sand are lifted off the floor by suction rather than pushed toward the outlet, because pushing them sends them into the house pipework and the heater.
-
3
High pressure wash
Walls, floor, corners and the area around the outlet, until the slime film is completely gone. This is the step that makes the sterilizing after it mean anything.
-
4
Sterilize, rinse, then return to service
The sterilizing agent goes onto the walls, the floor and the underside of the lid and is left for its contact time, then we rinse, refill and run the furthest tap until the whole line is clear.
What water tank sterilization includes
-
A recorded inspection
Material, capacity, sediment depth, the state of the lining, the lid and the overflow, all before any work begins.
-
Draining and sediment removal
The water out, and the silt and sand lifted off the floor instead of being pushed into the outlet and the house pipework.
-
High pressure washing
Walls, corners and around the outlet, until the biofilm that no disinfectant penetrates has gone.
-
Sterilizing the internal surfaces
A sterilizing agent meant for drinking water tanks, applied to the walls, the floor and the underside of the lid, and left for its contact time.
-
Line flush and aftercare
Rinse, refill and a flush from the furthest tap, when the water is usable again, and what to change in the filter afterwards.
-
The next cycle
We agree the right interval for your tank from how it is filled, how much sun it takes and the condition of the lid.
The character of Taybah
New development: ongoing construction and vacant plots between the homes
An emerging district means tanks are installed in an unstable environment. Construction debris enters the network easily and new tanks lack natural resistance. Strong and careful initial sterilization is essential before any occupancy.
Questions about this district
Does a brand-new tank need sterilizing before use?
Yes, even if water has never been filled. The tank may contain traces of manufacturing, transport and installation. Initial sterilization is essential before any consumption.
Do brown deposits indicate a tank problem or a network problem?
Usually the new network and surrounding excavation are the source. But an older tank may hold previous sediment layers. Inspection identifies the source.
How often should a tank in an emerging district like Taybah be sterilized?
In the first year, treatment every two to three months may be needed. After that, annual treatment is enough if the network stabilizes.
Is a covered tank better than an open one in an active building zone?
Much better. A covered tank reduces airborne dust and moisture entry. In Taybah where building continues, covering is essential.
Does tank sterilization remove chlorine odour from the main network?
Only partially. Sterilization disinfects the tank and lines but may add temporary chlorine smell. Full flushing removes all odour.
Can water be used immediately after sterilization?
No. Lines must be flushed fully and water allowed to run for several hours. First water may carry traces of the sterilizing agent.
How much does water tank sterilization in Taybah cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Taybah.
Nearby districts we cover
Other services in Taybah
Other services we provide to residents of Taybah.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sealing
-
Water tanks
Tank leak repair
-
Residential
Cockroach control
Need water tank sterilization in Taybah? Tell us what you saw and we will tell you what it needs
We reach Taybah at a time we agree, and you get the full cost before we start.