A technician wiping down a door handle during a disinfection visit
What our clients rate us

Disinfection in Salam Makkah

Salam is a mixed district where ground floor shops share buildings with residential flats above them, meaning pollutants travel easily through shared entrances and the spaces between units. Disinfection here cannot treat flats in isolation: it must reach the shared zones where commercial and residential traffic overlap.

  • Targeted, not broadcast

    Product goes into cracks and runways, never sprayed across open surfaces.

  • Told before we start

    What we will use, where it goes, and what to cover or move before we arrive.

  • A follow-up visit

    We return after the first treatment, because what survives it does not show on the day.

  • Homes and businesses

    Apartments and villas, and kitchens and stores that need a record of each visit.

Why they keep coming back in Salam

Shared stairs, lifts and entry doors face continuous traffic from shoppers and residents alike, so contaminants accumulate on these surfaces faster than in purely residential blocks. The method is set out in full on how we approach Disinfection.

The first reason

Shared spaces allow contamination to travel upwards

Moving air in stairwells and lift shafts carries pollutants from ground floor shops to upper residential flats. Treating only the shared entrance is not enough: ventilation openings and gaps around doors let contamination through from below.

The second reason

Shop and flat above must be timed together

If the flat is disinfected but the shop beneath remains untreated, pollutants return through shared voids. In Salam, treatment must be coordinated across different units in the same building to be effective.

The third reason

Ground floors hold damp longer and drain poorly

Ground floor spaces retain moisture more than upper flats, especially around drainage pipes and commercial waste water. This reduces disinfectant effectiveness unless the product is left wet for the full time needed on a damp surface.

Landmarks of Salam

Work in Salam is organised from entries near Engineer Omar Qadi Street and Al Qadisiyah Road, where most of the residential and commercial clusters lie. Treating the district requires coordination across shared spaces between these two main thoroughfares.

  • Engineer Omar Qadi Street
  • Al Qadisiyah Road
  • Al Sahaba Mosque
  • Al Sawwat Mosque
  • Haram Boundary Markers
Before treatment

What we look at before the product is chosen

The district lies inside the Haram boundary south of Al Sharai, bounded by Engineer Omar Qadi Street and Al Qadisiyah Road, with apartment buildings and villas on a regular grid between them.

A metal door handle in close up

The touch points

In Salam, the repeated touch points are lift buttons, stair handrails and door handles in shared entries, all pressed by hands from both shops and flats throughout the day.

Woven sofa upholstery in close up

Porous surfaces

Porous surfaces on ground floors hold moisture longer, especially external walls facing the street and areas around drainage pipes where seepage occurs.

A pale marble worktop in a kitchen

The finish itself

Shared stair and entry finishes are typically concrete or tile, both of which retain moisture and may need extended drying time after disinfection.

The filter and grille of an indoor air conditioning unit

The air conditioning unit

Air conditioning units in shops and flats may discharge contaminated air directly into shared stairwells, especially if their drainage outlets face toward the stairs.

A metal floor drain set into tiling

Floor traps

Floor traps in bathrooms and shop areas can carry odours into shared entries via common pipework, so they must be treated as part of the overall job.

A metal handrail in an apartment stairwell

Shared entrances and stairs

Shared entrances and stairs in Salam require extended treatment because they are where commercial and residential traffic meet, so contaminants accumulate faster there.

How we work

  1. 1

    Walk the space and list the surfaces

    We go through the rooms and mark the touch points, the porous surfaces and the finishes, then ask what prompted the call: illness at home, moving into a new place, building work, or a smell that arrived out of nowhere.

  2. 2

    Clean what we are about to treat

    We take the film of dust and grease off the surfaces that are in scope, so the product reaches the surface itself. This is preparation for the treatment, not general house cleaning.

  3. 3

    Apply it, and hold the contact time

    Hand work on the touch points, a product matched to each surface, and the surface left visibly wet for as long as that material needs before it is dried off. Cold fogging comes last, for what a cloth cannot reach.

  4. 4

    Ventilate and hand back

    We open the place up, rinse food preparation surfaces with water, and tell you when each room goes back into use. We give you that timing on the call, because it changes with the product and the space.

What a disinfection visit includes

  • A technician inspecting with a flashlight

    A surface and touch point survey

    What gets treated, and with what, settled before anything is opened.

  • A spray nozzle in close detail

    Soil off first, then the disinfectant

    The greasy film comes off first, then a product that stays wet for the contact time it needs.

  • A metal floor drain

    Floor traps and the air conditioning drain

    Floor traps, sink outlets and the drain tray, which is where most smells actually begin.

  • A spray nozzle in close detail

    Cold fogging for the space

    For upward faces and corners a cloth never reaches, done as the last thing before we leave a room.

  • A clean kitchen counter after treatment

    Ventilation and use instructions

    What gets rinsed with water, what is left alone, and when each room goes back into use.

  • The visit report being written on a clipboard

    A scheduled repeat when it is needed

    For shared entrances and places people pass through every day, because a disinfectant leaves nothing behind to stop the next contact.

What is different about Al Sharai Sub-Municipality

Al Sharai is the eastern growth front of Makkah along King Faisal Road and the Taif road. Settled quarters sit beside recently renamed schemes where plots are still vacant and buildings are going up, so construction sites, fill and open excavations lie next to occupied homes. Wadi channels such as Wadi Mudarraja, Wadi Al Sharai and Wadi Al Mughammas carry flash floods after rain and dry out to damp silt, while dust blows off the open hills. Roadside shops, restaurants and warehouses line the Taif road, and to the east the area shades into villages, palm farms and springs.

Questions about this district

Is disinfecting my flat enough if the ground floor shop stays untreated?

No, because contaminants move from the shop through shared entries and gaps between units. The flat and shop must either be treated together or at coordinated times to prevent re-entry.

Should we disinfect shared entrances separately and how often?

Yes, shared entrances serve multiple units and need separate treatment because traffic through them is constant. They may need more frequent disinfection than the individual flats themselves.

Does disinfection include treating ventilation openings between shops and flats?

Yes, these openings and gaps around pipes are the main routes for pollutants to travel between units. Treating them is essential to stop contamination moving between the commercial and residential parts.

Does a food shop need different treatment than a clothing shop above it?

Yes, food shops need closer attention because their contaminants pose a greater risk to the flats above, particularly food safety. The pollutants travel upward more readily.

Is it better to disinfect the district before or after peak shopping hours?

After peak hours is better so contaminants are not reintroduced immediately. But shared entrances may need treatment at specific times when foot traffic is lowest.

Can we stop shop odours by treating only the flat boundaries?

No, treating only the flat perimeter is not enough. The source of the smell in the shop and the channels between them must both be treated for lasting results.

How much does disinfection in Salam cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Salam.

Nearby districts we cover

Other services in Salam

Other services we provide to residents of Salam.

All services

Need disinfection in Salam? Tell us what you saw and we will tell you what it needs

We reach Salam at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp