Disinfection in Usaylah, Makkah

Targeted, not broadcast

Product goes into cracks and runways, never sprayed across open surfaces.
Told before we start

What we will use, where it goes, and what to cover or move before we arrive.
A follow-up visit

We return after the first treatment, because what survives it does not show on the day.
Homes and businesses

Apartments and villas, and kitchens and stores that need a record of each visit.

Why they keep coming back in Usaylah

Dust enters new homes through unfinished window frames and doorways before protection is installed, and new furniture and fresh timber hold factory moisture that leaves marks on walls within a week. The method is set out in full on Disinfection in detail.

The first reason

Construction dust from the active building sites

Building does not stop in Usaylah. Dust from excavation, mixing, and transport reaches newly occupied homes. It settles on every surface, and a dust film prevents the disinfectant from contacting the substrate beneath. We remove dust hours before disinfection or it will return and coat the newly treated surfaces.

The second reason

Open excavations and standing water

Foundations of new homes are dug deep, and water collects in these pits after every rare rainfall. The excavations become breeding grounds for mosquitoes, insects and rodents. Disinfection protects the home but insects return from outside, so we recommend concurrent pest control alongside the disinfection visit.

The third reason

Dampness from fresh concrete and high groundwater

New concrete and walls hold very high moisture content, and the Usaylah ground is rich in water tables. This moisture rises from walls as vapour and does not dry quickly. We leave the product wet for longer and allow walls to dry naturally before any space is closed off.

Usaylah on the map

Usaylah sits about 2.5 km from Badr and about 4 km from Maqam.

Open in Google Maps

Before treatment

What we look at before the product is chosen

The ground is open hillside with unfinished development and new building foundations that collect water after infrequent rain. Construction dust covers everything periodically, and the newly laid utilities are not yet fully protected from air and ground contaminants.

The touch points

Door handles, window frames and new wooden furniture hold dust and residual moisture, and disinfection leaves these surfaces wet, so we dry them with clean cloths when finished.

Porous surfaces

Fresh concrete surfaces have large pores and absorb water and product deeply, so we focus on the surface layer and small cracks that trap pathogens.

The finish itself

New paint is thin and not fully cured, and disinfectant may penetrate through to the substrate beneath. We wait at least a week until paint is fully dry before application.

The filter and grille of an indoor air conditioning unit

The air conditioning unit

Air conditioning units in new homes may not yet have been run, so we leave them off during disinfection and start them an hour after we finish to safely ventilate the villa.

Floor traps

Floor traps and drainage channels may not yet be tested, and standing water sits in them because construction is incomplete. We inspect these areas and remove building debris before disinfection starts.

A metal handrail in an apartment stairwell

Shared entrances and stairs

Doors and windows may be propped open from construction, so we close them firmly during disinfection to contain the product, and wait at least two hours before opening any window again.

How we work

1
Walk the space and list the surfaces

We go through the rooms and mark the touch points, the porous surfaces and the finishes, then ask what prompted the call: illness at home, moving into a new place, building work, or a smell that arrived out of nowhere.
2
Clean what we are about to treat

We take the film of dust and grease off the surfaces that are in scope, so the product reaches the surface itself. This is preparation for the treatment, not general house cleaning.
3
Apply it, and hold the contact time

Hand work on the touch points, a product matched to each surface, and the surface left visibly wet for as long as that material needs before it is dried off. Cold fogging comes last, for what a cloth cannot reach.
4
Ventilate and hand back

We open the place up, rinse food preparation surfaces with water, and tell you when each room goes back into use. We give you that timing on the call, because it changes with the product and the space.

What a disinfection visit includes

A surface and touch point survey

What gets treated, and with what, settled before anything is opened.
Soil off first, then the disinfectant

The greasy film comes off first, then a product that stays wet for the contact time it needs.
Floor traps and the air conditioning drain

Floor traps, sink outlets and the drain tray, which is where most smells actually begin.
Cold fogging for the space

For upward faces and corners a cloth never reaches, done as the last thing before we leave a room.
Ventilation and use instructions

What gets rinsed with water, what is left alone, and when each room goes back into use.
A scheduled repeat when it is needed

For shared entrances and places people pass through every day, because a disinfectant leaves nothing behind to stop the next contact.

What is different about Al Sharai Sub-Municipality

Al Sharai is the eastern growth front of Makkah along King Faisal Road and the Taif road. Settled quarters sit beside recently renamed schemes where plots are still vacant and buildings are going up, so construction sites, fill and open excavations lie next to occupied homes. Wadi channels such as Wadi Mudarraja, Wadi Al Sharai and Wadi Al Mughammas carry flash floods after rain and dry out to damp silt, while dust blows off the open hills. Roadside shops, restaurants and warehouses line the Taif road, and to the east the area shades into villages, palm farms and springs.

Questions about this district

Does construction dust from nearby building sites enter new villas from inside?

It does, extensively. Dust reaches homes through window openings, doors and paint cracks. We wash walls and floors of dust hours before disinfection. If building sites are very close, we advise repeat disinfection one week later.

Can rodents and insects from vacant plots reach the new villa through underground gaps?

Yes. Open excavations and empty plots provide shelter, water and pathways for rodents and insects. Disinfection kills microbes, but insects return from outside. We recommend complete ground treatment around the villa alongside the disinfection.

When can new furniture be moved into a newly built villa after disinfection?

Once the disinfectant is completely dry, in four to six hours. However, new furniture holds moisture from the factory and transport, so we recommend opening all wardrobes, drawers and storage before the home is lived in.

Does fresh concrete in new villas need treatment before disinfection starts?

Yes. If possible, leave the villa open for ventilation a week before disinfection. Concrete needs time to dry completely. If speed is necessary, disinfect at least two days after construction finishes.

Will rust from exposed iron fittings worsen with disinfectant moisture in new homes?

Yes. The disinfectant leaves damp conditions, and bare iron rusts rapidly. We recommend protecting exposed metal with a sealant coat before disinfection.

After disinfection in Usaylah, will the smell of new paint and concrete disappear?

No. Disinfection does not address paint fumes or concrete odour. These are natural and fade with continuous ventilation. We open all windows for the first full day after disinfection to air the villa thoroughly.

How much does disinfection in Usaylah cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Usaylah.