Tank leak repair in Al Adl Makkah
Al Adl extends eastward along King Faisal Road and the fourth ring road, with high-density apartment blocks and pilgrim housing. Tanks here face continuous pressure from seasonal water demand surges, and leaks appear quickly in foundations and floor slabs of the newer buildings.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Adl
Buildings here are recently constructed and tanks meet modern standards, but high pressure and rapid expansion mean tanks require regular inspection schedules. The method is set out in full on the full Tank leak repair page.
Roof tanks in new apartment blocks
Most tanks here sit on building rooftops connected by flexible and rigid steel pipe runs. Leaks often occur at pipe joints and where the inlet enters the tank, due to high pressure and thermal movement.
Modern foundations and sealed floor slabs
Foundations are modern reinforced concrete and floors are sealed with tile and ceramic. Tank leaks spread beneath floor slabs and may not appear for weeks, causing internal damage.
Seasonal demand surges and high pressure
The quarter hosts seasonal pilgrim arrivals and variable residents, spiking water demand sharply. High pressure on pipes and tanks accelerates the emergence of small leaks.
Landmarks of Al Adl
Access to Al Adl buildings is via King Faisal Road and the fourth ring road, with Jabal Al Nour as a clear northern landmark. The Board of Grievances, the health centre and Jarir bookstore pin the district location precisely.
- King Faisal Road
- Fourth Ring Road
- Jarir Bookstore
- Board of Grievances
- Jabal Al Nour
Where the water leaves decides how it is repaired
A modern residential quarter east of Jeddah on King Faisal Road, bounded by Jabal Al Nour to the north, Al Rawdah to the south and the holy sites to the east, with a health centre and modern retail facilities.
Damp and salt on the outside wall
Float valve and sensor precision: high pressure in Al Adl buildings accelerates wear on valve seats and seal.
The kind of crack
Pipe joints, elbows and flexible connections: modern rigid and flexible runs in new buildings are prone to leaks from pressure surge and thermal cycling.
The wall to floor junction
Tank walls inside and out for cracks and moisture: new tanks may have minor concrete voids or welding defects.
Pipe entries
Tank floor and corners for pooling water: moisture collects in low spots where small cracks begin to fail.
The condition of the old lining
Pipe outlet, strainer and tank collar: the pipe entry to the tank is a common leak point in modern tanks under pressure.
What the tank is made of
Building floors and ground-floor walls for moisture stains: leaks from roof tanks can travel down long pipe runs and show as damp patches below.
How we work
-
1
Inspect and locate the leak
We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.
-
2
Drain, clean and dry
We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.
-
3
Repair the cracks and the entries
We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.
-
4
Refill, test, then sterilise
We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.
What tank leak repair includes
-
A marked level test
A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.
-
Draining and sediment removal
Water and silt out of the base, so the floor and the walls can be seen as they really are.
-
Pressure wash and dry back
The weak layer and the dust come off, because a repair only holds on sound concrete.
-
Cracks opened and filled
The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.
-
Refill and a recorded test
We refill, read the level again and write the reading down, so the result is not a matter of opinion.
-
Sterilised and back in service
A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.
What is different about Al Maabdah Sub-Municipality
Al Maabdah sub municipality climbs from Al Abtah and Al Jumayzah beside the Al Mualla cemetery up through Al Khansa and Rai Adhakhir to Al Adl, Jabal Al Nour, Wadi Jaleel and Qurtubah on the outer ring roads. It mixes hotels and pilgrim housing near the Grand Mosque with old popular houses on hillside passes, new housing schemes on valley floors that carry flash floods after rain, and industrial plots, workshops and warehouses along Al Hajj Street in Qurtubah. Street widening and expropriation leave partly demolished frontages in Al Khansa.
Questions about this district
How do we know if a leak is in the tank or the pipes?
We close the float valve and the outlet valve and watch the level. If it falls, the leak is in the tank. If it holds steady, the fault is in the pipes.
Why do leaks appear suddenly in new buildings?
High pressure on pipes and thermal expansion and contraction cause small cracks at joints. New tanks may contain manufacturing defects that only appear under sustained pressure.
Can a leak under the floor be repaired without breaking tiles?
If the leak is in a pipe beneath the floor, we may need to cut a section of tile. But if it is from the tank or its joint, repair is done at roof level or in the tank room.
Is tank lining enough to repair a leak?
Lining does not replace proper repair. We fix cracks or pipe entry faults first, then apply lining only if needed for long-term protection.
How often should tanks be inspected in large residential blocks?
In a fast-growing quarter like Al Adl, tanks should be checked every six months. Inspection covers pipes, float valves and internal walls.
Do modern tanks leak less than older ones?
Modern tanks are better but not leak-proof. Leaks occur from pressure and heavy use, not age alone.
How much does tank leak repair in Al Adl cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Adl.
Nearby districts we cover
Other services in Al Adl
Other services we provide to residents of Al Adl.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sterilization
-
Water tanks
Water tank sealing
-
Residential
Cockroach control
Need tank leak repair in Al Adl? Tell us what you saw and we will tell you what it needs
We reach Al Adl at a time we agree, and you get the full cost before we start.