Tank leak repair in Al Rawabi Jeddah
Al Rawabi is a densely populated district in south Jeddah with an old section and a new one. Apartment blocks are numerous and roof tanks serve large numbers of units. Leaks here are frequent because pressure is high and use is intense, especially at peak times.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Rawabi
Apartment buildings are numerous and many units are occupied; each roof tank serves dozens of flats across multiple floors. The method is set out in full on Tank leak repair in detail.
Shared roof tanks serving dozens of units
Each Al Rawabi apartment block holds a shared roof tank serving 50 to 100 units or more. Pressure on tank and pipes is very high, and leaks from fittings are common.
Vertical pipes under intense demand pressure
Pipes drop from the roof tank through multiple storeys. At morning and evening peak times, pressure is extreme and old pipes leak from seams and fittings.
Small shopping centres contain separate tanks
Shopping centres and small shops in the district hold separate tanks, some old and some new. Leaks from small tanks affect neighbouring shops because spaces are tight.
The character of Al Rawabi
Mixed district: shops at street level with homes above them
A densely residential district means shared tanks serving large numbers under sustained high pressure. Repair requires coordination with building management and residents and may need temporary supply cuts affecting dozens of units. Old tanks often require full replacement rather than repeated patching to avoid recurring failures.
Where the water leaves decides how it is repaired
A densely populated residential district in south Jeddah in two sections: a newer northern part crossed by Bin Laden Road and an older southern strip along Old Makkah Road. Many apartment buildings alongside small shopping centres and neighbourhood parks.
Damp and salt on the outside wall
Overflow leaks from top fittings of shared tanks or from overflow pipes on upper floors.
The kind of crack
Fitting and inlet pipe leaks in roof tanks; pipe leaks from metal seams and junctions.
The wall to floor junction
Small cracks in old tank bodies, especially at corners and base.
Pipe entries
Damp marks around the base of roof tanks on terraces and on external building walls.
The condition of the old lining
Water pooling under tanks on roofs indicates base or seam leaks.
What the tank is made of
Dripping water from interior ceilings of upper floors indicates leaks in pipes or the tank itself.
How we work
-
1
Inspect and locate the leak
We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.
-
2
Drain, clean and dry
We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.
-
3
Repair the cracks and the entries
We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.
-
4
Refill, test, then sterilise
We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.
What tank leak repair includes
-
A marked level test
A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.
-
Draining and sediment removal
Water and silt out of the base, so the floor and the walls can be seen as they really are.
-
Pressure wash and dry back
The weak layer and the dust come off, because a repair only holds on sound concrete.
-
Cracks opened and filled
The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.
-
Refill and a recorded test
We refill, read the level again and write the reading down, so the result is not a matter of opinion.
-
Sterilised and back in service
A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.
What is different about Al Jamiah Sub-Municipality
Al Jamiah sub municipality spans the older south of Jeddah. Planned districts such as Al Fayha, Al Thaghr and Madain Al Fahd sit beside crowded popular quarters like the Nazlahs and Al Quraiyat, and beside cleared or clearing land in Ghulail, Petromin and Al Thaalibah awaiting redevelopment. Apartment buildings stand close together above dense runs of shops and restaurants along Old Makkah Road and Prince Majid Road. Drainage in the popular quarters is ageing, humid air drifts in from the port and refinery side to the west, and the flat low lying ground holds rainwater in narrow streets.
Questions about this district
Why do leaks increase at morning and evening peak times?
Pressure on pipes rises sharply when all units use water together. High pressure accelerates wear on old fittings and pipes.
Does repairing a leak in a shared tank need all residents' approval?
Often yes, because the tank is shared and repair may require temporary water cuts affecting all residents.
How do we know the leak is in the tank not in pipes inside individual units?
We close the overflow valve and outlet and watch the level. If it falls, the leak is in the tank or common pipes. If stable, the leak is in an individual flat.
Is repairing one fitting enough to stop repeated leaks in a shared tank?
It may not be. If the tank is old with several weak fittings, multiple repairs or fitting replacements may be needed.
Do small shops in the district ever have very old tanks?
Yes. Some small shops have very old tanks not serviced for years. Leaks in them are frequent.
How often does a shared tank need routine maintenance to avoid leaks?
A shared tank serving dozens of units needs inspection at least yearly. Cleaning every one or two years helps prevent rust and leaks.
How much does tank leak repair in Al Rawabi cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Rawabi.
Nearby districts we cover
Other services in Al Rawabi
Other services we provide to residents of Al Rawabi.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sterilization
-
Water tanks
Water tank sealing
-
Residential
Cockroach control
Need tank leak repair in Al Rawabi? Tell us what you saw and we will tell you what it needs
We reach Al Rawabi at a time we agree, and you get the full cost before we start.