Water tank sterilization in Al Buhayrat Makkah
Al Buhayrat is a new northwestern extension between An Nawwariyah and As Salamah, near At Tanim and the northern Haram boundary. New villas and apartment blocks stand alongside plots still under construction. Tanks here are relatively new but face problems from construction instability and rainwater infiltration into the soil.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Al Buhayrat
Buildings here were completed in the past decade or are currently under construction, and tanks are under pressure from rapid population growth and urban development. The method is set out in full on how we approach Water tank sterilization.
New tanks in buildings still under active construction
Most villas and apartment buildings are recently built or still under construction. Tanks are exposed to dust, sand and construction materials entering during building and finishing work.
Rains and flooding affect tank integrity
The district lies in a relatively low-lying area near the Haram boundary. Seasonal rains introduce contaminated water into tanks through openings and seepage. New development changes water flow patterns.
Structural instability and irregular maintenance
New buildings may have tanks that are not perfectly balanced or sealed after construction. Irregular maintenance by new owners means tanks are not cleaned systematically.
The character of Al Buhayrat
Mixed district: shops at street level with homes above them
New and mixed residential areas mean tanks are modern but built rapidly during a period of fast expansion. Treatment focuses on removing construction deposits and verifying wall and insulation integrity before sterilizer application.
What we read inside the tank before anything starts
A new mixed residential extension northwest between An Nawwariyah and As Salamah, near At Tanim mosque and the northern Haram boundary. Apartment buildings and new villas with Hira General Hospital and small commercial areas.
Sediment on the floor
Deposits from construction materials, cement and fine sand accumulate on the tank floor especially in early use.
The slime film on the wall
Algae and biofilm form on walls from rainwater entry and light exposure at ventilation openings.
Light and heat
Distribution lines from new tanks to villas and apartments may hold deposits and bacteria from construction.
The lining and any cracking
High humidity from rain, irrigation and proximity to Haram causes moisture buildup in tanks and pipes.
The lid and the openings
Bacteria and fungi settle at pipe joints, wall connections and floor where water pools.
What shows up at the tap
Signs of contamination appear as cloudy water and odd odours immediately after rainfall.
How we work
-
1
Inspect and record the condition
We open the hatch and work through what the tank is made of and how big it is, how deep the sediment lies, the state of the lining, whether the lid and the overflow seal, and whether there is a crack that has to be repaired before any sterilizing.
-
2
Drain and lift the sediment out
The water goes out, then the silt and sand are lifted off the floor by suction rather than pushed toward the outlet, because pushing them sends them into the house pipework and the heater.
-
3
High pressure wash
Walls, floor, corners and the area around the outlet, until the slime film is completely gone. This is the step that makes the sterilizing after it mean anything.
-
4
Sterilize, rinse, then return to service
The sterilizing agent goes onto the walls, the floor and the underside of the lid and is left for its contact time, then we rinse, refill and run the furthest tap until the whole line is clear.
What water tank sterilization includes
-
A recorded inspection
Material, capacity, sediment depth, the state of the lining, the lid and the overflow, all before any work begins.
-
Draining and sediment removal
The water out, and the silt and sand lifted off the floor instead of being pushed into the outlet and the house pipework.
-
High pressure washing
Walls, corners and around the outlet, until the biofilm that no disinfectant penetrates has gone.
-
Sterilizing the internal surfaces
A sterilizing agent meant for drinking water tanks, applied to the walls, the floor and the underside of the lid, and left for its contact time.
-
Line flush and aftercare
Rinse, refill and a flush from the furthest tap, when the water is usable again, and what to change in the filter afterwards.
-
The next cycle
We agree the right interval for your tank from how it is filled, how much sun it takes and the condition of the lid.
What is different about Al Umrah Sub-Municipality
Al Umrah sub municipality covers the north west of Makkah along the Madinah road and the old Jeddah road, from At Tanim and Masjid Aisha to An Nawwariyah. Its districts are the city's newest, villas and apartment blocks raised on wide schemes where large tracts in Al Umrah Al Jadidah, Al Fayha and Al Buhayrat remain vacant or under construction. Wadi Saraf and Wadi At Tanim run through it and rainwater gathers on unfinished schemes, ihram shops, restaurants and coach stops along the Madinah road serve a constant flow of pilgrims, and villas fill Al Hamra and Umm Al Jud.
Questions about this district
Do new tanks need sterilization more than old tanks?
Yes. New tanks may contain deposits from construction materials and cement from the building process. Early sterilization is important before heavy use.
Does rainwater entering the tank need special treatment?
Yes. Rainwater may carry contaminants from surfaces and soil. We focus on removing deposits and contaminated water and applying full tank sterilization.
How often should we sterilize a tank per year in this area?
We recommend sterilization every six months at minimum, and immediately after any flood or contaminated water entry.
Do insulated tanks need different treatment?
Insulated tanks are better but may hold bacteria in the insulation layers. We flush the insulation carefully and inject sterilizer into all corners.
Can we use the water immediately after sterilization?
After complete flushing and sterilization, water is safe to use. We recommend flushing the lines by running water for half an hour.
What if the tank is leaking or has cracks?
If the leak is small, we sterilize first. If the leak is large, we recommend repair or replacement before sterilization.
How much does water tank sterilization in Al Buhayrat cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Al Buhayrat.
Nearby districts we cover
Other services in Al Buhayrat
Other services we provide to residents of Al Buhayrat.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sealing
-
Water tanks
Tank leak repair
-
Residential
Cockroach control
Need water tank sterilization in Al Buhayrat? Tell us what you saw and we will tell you what it needs
We reach Al Buhayrat at a time we agree, and you get the full cost before we start.