Tank leak repair in Safa Makkah
Safa is a new development district south of the Al Sharai municipality, wide open spaces between Jabal Al Tariqi and the channels of Wadi Al Sharai and Wadi Urana. Buildings here are newly built and tanks recently installed, but sandy soil, gravel-based foundations and groundwater seepage cause leaks at pipe entry points and through tank walls.
-
Potable-rated materials
Linings and disinfectants cleared for drinking water tanks, not general-purpose products.
-
You get the downtime first
How many hours the tank is out of service, told before we start rather than after we finish.
-
A first-draw flush
We run the first draw off after refilling, and the tank is not handed back until the water runs clear.
-
Ground and roof tanks
Villas, apartment blocks and premises that need a written record of each visit.
Why the job is different in Safa
Buildings are very new and tanks recently fitted, but unstable sandy and rocky soil causes settling and foundation movement that cracks pipes and tank seals. The method is set out in full on what Tank leak repair involves.
Pipes on unstable sandy ground
Pipes from tank to house are laid on sandy and rocky soil that shifts with moisture and drying cycles. Movement breaks pipe joints and cracks plastic pipe runs.
The first pipe entry point is vulnerable to leak
The entry point sits under constant water pressure, and sandy soil causes minor movement of the pipe position. Stress and pressure crack the seal or the entry itself.
High groundwater seepage in the area
Wadi Al Sharai and nearby channels provide high moisture and groundwater close to the surface. New tanks may not be fully sealed against external moisture.
Landmarks of Safa
Safa is bounded by Wadi Al Sharai channels to the north and east, Wadi Urana to the south and Jabal Al Tariqi to the west, and these natural boundaries define the service zone.
- Wadi Urana
- Wadi Al Sharai
- Jabal Al Tariqi
Where the water leaves decides how it is repaired
A newly developed district south west of Al Mughammas on open ground with few buildings, far from services and bordered by wadi channels.
Damp and salt on the outside wall
Closing the float valve, outlet and drain line tells us the real rate of water loss without use affecting the result.
The kind of crack
Inspecting the tank for cracks is done after full drying, and hairline cracks may be inside the tank walls only.
The wall to floor junction
The first pipe entry point, rubber seal and gasket rings are a common leak source in new tanks.
Pipe entries
Pipes laid on the surface break or crack from sandy soil movement, and we may need to re-secure them with additional brackets.
The condition of the old lining
Groundwater seepage causes external leaks from the tank base, and we may need to drain groundwater before repair.
What the tank is made of
Testing the level after repair and drying must continue for hours to confirm no new leak appears.
How we work
-
1
Inspect and locate the leak
We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.
-
2
Drain, clean and dry
We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.
-
3
Repair the cracks and the entries
We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.
-
4
Refill, test, then sterilise
We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.
What tank leak repair includes
-
A marked level test
A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.
-
Draining and sediment removal
Water and silt out of the base, so the floor and the walls can be seen as they really are.
-
Pressure wash and dry back
The weak layer and the dust come off, because a repair only holds on sound concrete.
-
Cracks opened and filled
The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.
-
Refill and a recorded test
We refill, read the level again and write the reading down, so the result is not a matter of opinion.
-
Sterilised and back in service
A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.
What is different about Al Sharai Sub-Municipality
Al Sharai is the eastern growth front of Makkah along King Faisal Road and the Taif road. Settled quarters sit beside recently renamed schemes where plots are still vacant and buildings are going up, so construction sites, fill and open excavations lie next to occupied homes. Wadi channels such as Wadi Mudarraja, Wadi Al Sharai and Wadi Al Mughammas carry flash floods after rain and dry out to damp silt, while dust blows off the open hills. Roadside shops, restaurants and warehouses line the Taif road, and to the east the area shades into villages, palm farms and springs.
Questions about this district
How do we know if the leak is the tank itself or the pipes?
We close the float valve and outlet and outlet line and watch the level. If it falls without use, the leak is the tank. If it holds steady, the problem is the pipes.
Why do leaks happen in new tanks in Safa?
Unstable sandy soil causes foundation settlement. Movement cracks the tank or pipes at pressure points like the inlet.
Is lining the tank enough without fixing the cracks first?
No. Lining stops water seeping for a while but does not fix the root cause. Cracks and entry points must be repaired first.
Is the water safe to use after repair?
After cracking is repaired and the tank drained, cleaned and dried, refill it and wait hours to confirm no new leak before use.
What do we check at the first pipe entry point?
We inspect the seal ring, rubber gaskets and fine cracks in the concrete around the entry. Leaks often start here due to pressure.
Does soil movement mean we will return to repair again?
If we repair the cracks and the leak and secure the pipe firmly, the problem ends. Soil movement is minor and settles within a year of building.
How much does tank leak repair in Safa cost?
It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Safa.
Other services in Safa
Other services we provide to residents of Safa.
-
Water tanks
Water tank cleaning
-
Water tanks
Water tank sterilization
-
Water tanks
Water tank sealing
-
Residential
Cockroach control
Need tank leak repair in Safa? Tell us what you saw and we will tell you what it needs
We reach Safa at a time we agree, and you get the full cost before we start.