A technician checking the inside wall of a concrete water tank with a torch
What our clients rate us

Tank leak repair in Wali Al Ahd Makkah

Wali Al Ahd is a rapidly growing residential quarter south of Al Shawqiyah on Al Layth Road near the Fourth Ring. Three-storey apartment buildings stand among residential plots still under development. Tanks here are a mix of old and new, and leaks may result from plan changes during construction or pipes that were relocated.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Wali Al Ahd

Buildings are a mix of old and new, construction plans change rapidly affecting pipe routing and tank placement. Leaks appear especially in buildings undergoing development. The method is set out in full on our Tank leak repair service.

The first reason

Plan changes during construction affect pipe routing

Modern schemes mean some buildings have been replanned. Pipes have been relocated or new tanks added above old ones. New connections are weak points.

The second reason

Old tanks with new pipework

Some buildings have old steel tanks but new copper pipes. Material mismatch and loose connections create vulnerabilities.

The third reason

Tight spaces and complex pipe passages

Three-storey blocks in confined plots. Pipes run through tight passages between walls and units. Leaks may be hidden because water seeps inside walls.

Wali Al Ahd on the map

Wali Al Ahd sits about 2 km from Al Ukayshiyah and about 3 km from Al Shawqiyah.

Open in Google Maps
Before treatment

Where the water leaves decides how it is repaired

A developing residential quarter south of Al Shawqiyah inside the Haram boundary, with three-storey apartment buildings and residential plots under new schemes. Al Layth Road passes through and the Fourth Ring lies close by, with mosques, parks and a health centre serving residents.

A concrete wall marked with damp and a white salt bloom

Damp and salt on the outside wall

Tank inspection: close valves and monitor water level to determine if the leak is from the tank or the pipes.

A fine crack running across a concrete surface

The kind of crack

Joint inspection: connections between old tanks and new pipes are obvious weak points in this mixed quarter.

The corner where a concrete floor meets a wall

The wall to floor junction

Wall pipe inspection: new copper pipes may leak inside walls in tight passages not directly visible.

Water pipes passing through a concrete wall

Pipe entries

Stacked tank inspection: some buildings have an old tank with a new one above it, and the leak may be between them.

A blistered and peeling layer on a concrete surface

The condition of the old lining

New construction point inspection: where pipes were relocated or new connections added, weak points may exist.

A white plastic water tank standing outside

What the tank is made of

Hidden leak inspection: if water level drops but no water shows, the leak is inside walls or behind surfaces.

How we work

  1. 1

    Inspect and locate the leak

    We close the float valve and the outlet, mark the water level and watch it fall, then check the fittings and the wall beside it. That separates a tank leak from a pipe leak or a float valve that never shuts.

  2. 2

    Drain, clean and dry

    We empty the tank, lift the sediment off the base, wash back to sound concrete and let the surface dry. No repair holds on a damp or dusty face.

  3. 3

    Repair the cracks and the entries

    We cut the crack open, fill it with a non-shrink mortar, inject anything still weeping and rebuild around the pipe sleeve. A joint that moves takes a flexible detail, not a rigid one.

  4. 4

    Refill, test, then sterilise

    We refill, read the level again to confirm the drop has stopped, then sterilise before the water is used, because the tank has been open with tools and hands inside it.

What tank leak repair includes

  • A technician inspecting with a flashlight

    A marked level test

    A reading before and after with everything shut, which establishes that the loss is the tank and not the plumbing.

  • A metal floor drain

    Draining and sediment removal

    Water and silt out of the base, so the floor and the walls can be seen as they really are.

  • A spray nozzle in close detail

    Pressure wash and dry back

    The weak layer and the dust come off, because a repair only holds on sound concrete.

  • A gloved hand applying bait into a joint

    Cracks opened and filled

    The crack is cut open and filled with a non-shrink mortar, and anything still weeping under water pressure is injected.

  • The visit report being written on a clipboard

    Refill and a recorded test

    We refill, read the level again and write the reading down, so the result is not a matter of opinion.

  • A clean kitchen counter after treatment

    Sterilised and back in service

    A wash and a sterilisation once the material has cured, and guidance on running the first fill off before the water is used.

The character of Wali Al Ahd

New development: ongoing construction and vacant plots between the homes

A developing quarter means a mix of old and new buildings being moved and changed. Tanks and pipes are often mixed ages and types. Treatment requires understanding the mixed structure and changes made during construction.

Questions about this district

Why is leaking common in a developing quarter like Wali Al Ahd?

Building plans change and pipes are relocated or added quickly. New connections and rushed installations create many weak points.

Does an old tank with new pipes cause problems?

Yes. Different materials may not match. Old steel and new copper create chemical reactions at joints.

How do we detect a leak if it is hidden inside walls in dense buildings?

We monitor water level by closing valves. If it drops but no water shows, the leak is inside walls and we may need broader investigation.

Is replacing the tank cheaper than fixing a persistent leak?

Possibly. But first we identify the cause. If it is the pipes not the tank, repair is cheaper.

Does treatment differ between an old and a new building in the same quarter?

Yes. An old building may need tank replacement; a new one may only need to fix a pipe joint.

How do we handle pipes inside walls in tight buildings?

We trace pipes from the entry point. If the leak is too deep, we may need to open part of the wall to reach it.

How much does tank leak repair in Wali Al Ahd cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Wali Al Ahd.

Nearby districts we cover

Other services in Wali Al Ahd

Other services we provide to residents of Wali Al Ahd.

All services

Need tank leak repair in Wali Al Ahd? Tell us what you saw and we will tell you what it needs

We reach Wali Al Ahd at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp