A technician washing the inside wall of a water tank with a high pressure hose
What our clients rate us

Water tank sterilization in Jabal Al Noor Makkah

Jabal Al Noor draws a constant flow of visitors and pilgrims, and residential buildings and hotels surrounding it serve this continuous demand. Tanks here carry high daily-use loads, and water passes through old pipes that may compromise quality. Regular sterilization is essential to ensure clean water for hundreds of residents and guests daily.

  • Potable-rated materials

    Linings and disinfectants cleared for drinking water tanks, not general-purpose products.

  • You get the downtime first

    How many hours the tank is out of service, told before we start rather than after we finish.

  • A first-draw flush

    We run the first draw off after refilling, and the tank is not handed back until the water runs clear.

  • Ground and roof tanks

    Villas, apartment blocks and premises that need a written record of each visit.

Why the job is different in Jabal Al Noor

Buildings here mix old and new construction, and water consumption is very high due to continuous visitors and hotels, raising the risk of rapid sediment and contaminant buildup. The method is set out in full on how we approach Water tank sterilization.

The first reason

Old pipes beneath King Faisal Road

Mains water pipes beneath the main road pass through damp soil and corroded metal. Pipe walls carry layers of rust and calcium scale that flake slowly into the water.

The second reason

Hotels and apartment blocks demand heavy water flow

Hotels surrounding Jabal Al Noor consume vast amounts from restaurants, bathrooms and laundry. This heavy draw pulls water quickly and sediment settles before discharge.

The third reason

Seasonal demand peaks: Hajj and Umra spikes

During Hajj and Umra seasons hotels fill with guests and water demand spikes. Home and hotel tanks empty and refill at high speed, stirring up base sediment.

Jabal Al Noor on the map

Jabal Al Noor sits about 1.5 km from Al Adl and about 2.5 km from Al Khansa.

Open in Google Maps
Before treatment

What we read inside the tank before anything starts

A densely built residential zone around Jabal Al Noor on King Faisal Road, containing apartment buildings, hotels and retail shops. It is bounded by the Al Moallah road to the south and Al Adl to the east, overlooking Souq Al Arab and the sacred zones.

Fine wet sand seen close up

Sediment on the floor

Metal sediment from old King Faisal Road pipes enters water at higher concentration during periods of heavy draw.

A concrete wall carrying a damp green layer

The slime film on the wall

Mains water carrying residue from hundreds of guests holds soap, shampoo and salt, and biofilm forms rapidly on tank walls.

A plastic water tank standing on a rooftop

Light and heat

Internal pipes in hotels and buildings may also be old, and rust and deposits accumulate fast under high pressure and continuous draw.

A concrete surface carrying fine cracks

The lining and any cracking

Humidity, heat and light entering through vent openings provide ideal conditions for algae and bacterial growth.

A metal cover over a water tank opening

The lid and the openings

Biofilm and algae form on tank walls rapidly due to repeated fast draws and continuous sediment feed.

A glass of water on a kitchen counter

What shows up at the tap

Bacterial activity peaks during Hajj and Umra seasons, requiring intensive and timely sterilization before and during the season.

How we work

  1. 1

    Inspect and record the condition

    We open the hatch and work through what the tank is made of and how big it is, how deep the sediment lies, the state of the lining, whether the lid and the overflow seal, and whether there is a crack that has to be repaired before any sterilizing.

  2. 2

    Drain and lift the sediment out

    The water goes out, then the silt and sand are lifted off the floor by suction rather than pushed toward the outlet, because pushing them sends them into the house pipework and the heater.

  3. 3

    High pressure wash

    Walls, floor, corners and the area around the outlet, until the slime film is completely gone. This is the step that makes the sterilizing after it mean anything.

  4. 4

    Sterilize, rinse, then return to service

    The sterilizing agent goes onto the walls, the floor and the underside of the lid and is left for its contact time, then we rinse, refill and run the furthest tap until the whole line is clear.

What water tank sterilization includes

  • A technician inspecting with a flashlight

    A recorded inspection

    Material, capacity, sediment depth, the state of the lining, the lid and the overflow, all before any work begins.

  • A metal floor drain

    Draining and sediment removal

    The water out, and the silt and sand lifted off the floor instead of being pushed into the outlet and the house pipework.

  • A spray nozzle in close detail

    High pressure washing

    Walls, corners and around the outlet, until the biofilm that no disinfectant penetrates has gone.

  • A spray nozzle in close detail

    Sterilizing the internal surfaces

    A sterilizing agent meant for drinking water tanks, applied to the walls, the floor and the underside of the lid, and left for its contact time.

  • A clean kitchen counter after treatment

    Line flush and aftercare

    Rinse, refill and a flush from the furthest tap, when the water is usable again, and what to change in the filter afterwards.

  • The visit report being written on a clipboard

    The next cycle

    We agree the right interval for your tank from how it is filled, how much sun it takes and the condition of the lid.

The character of Jabal Al Noor

Apartment district: residential blocks, repeated floors and shared entrances

A densely packed residential zone with tourist hotels means tanks endure intense and seasonal consumption pressure. Old and new buildings are mixed, pipes vary in age, so cleaning and sterilization must account for the range of pipe and tank quality and uneven draw patterns.

Questions about this district

Do old pipes beneath King Faisal Road affect water quality?

Yes. Rust and scale from old pipes enter the water slowly. Water may reach the tank with a metallic smell or slight discoloration.

How often should a hotel tank on Jabal Al Noor be sterilized?

Hotels consume water heavily and fast. Sterilization every three to four months is needed to maintain water safety.

Do visitors and pilgrims cause tank problems?

Indirectly. Heavy demand pulls water fast, stirring sediment and muddying it. Guests may notice unusual taste or colour.

Is one tank cleaning per year enough for the whole year?

In ordinary residential areas it may suffice. But in Jabal Al Noor, high consumption and seasonality mean at least two cleanings are necessary.

Why does water in hotels sometimes taste odd?

Rust and sediment from pipes and tanks leave a metallic taste. Regular sterilization and cleaning removes it.

Does sterilizing one tank in a hotel protect all rooms?

Yes, if distribution comes from one tank. But some hotels have multiple tanks or individual room tanks needing separate sterilization.

How much does water tank sterilization in Jabal Al Noor cost?

It is set after the inspection, because the price follows the type of infestation, the size of the space, how far it has spread and the number of visits it needs. Send a photo and a description on WhatsApp and we will give you an estimate before we reach Jabal Al Noor.

Nearby districts we cover

Other services in Jabal Al Noor

Other services we provide to residents of Jabal Al Noor.

All services

Need water tank sterilization in Jabal Al Noor? Tell us what you saw and we will tell you what it needs

We reach Jabal Al Noor at a time we agree, and you get the full cost before we start.

Call now +966 57 336 7012 WhatsApp